EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

MRT18BRAZ0 Frigidaire Refrigerator - Instructions

All Instructions for the MRT18BRAZ0
106 - 120 of 202

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refrig would not defrost
  • Robert from Jacksonville, FL
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Diagnosis: used wiring diagram attached to frig and determined cause could be wiring, heater element, thermostat or timer. After completely defrosting the frig (turned it off) I removed the rear cover in the freezer and looked for an obvious problem. None seen. Removed temperature select pod from the frig box and looked for obvious pro blems. None seen but defrost timer appeared poorly made. Repair: Since I had no practical way of checking the defrost cycle in operation, I checked probable failures on the Part Select website and saw defrost timer as most probable. I ordered the timer. Installed it. Waited a few days to make sure the frig went through a few defrost cycles then removed the freezer rear cover. There was no excessive frost buildup so I'm reasonably sure the repair was successful.
Was this helpful?
Thank you for voting!
frig side not cool/freezer coils not defrosting
  • daryl from n.las vegas, NV
  • Really Easy
  • Less than 15 mins
unplugged frig,removed bottom front cover and loosend 2 screws at bottom front left and slid defrost timer out from behind metal panel,unplugged the old and plugged in the new.frig works great.
Was this helpful?
Thank you for voting!
compressor not running
  • wilson from indialantic, FL
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Wrench (Adjustable)
thanks to all of the people who had the same problems I was able to make a quick fix on my fridge. I pulled the back cover off and found the compressor not kicking on so I replaced the start cap. and im back in bussiness.
Was this helpful?
Thank you for voting!
freezer frosted up and air could not circulate to the food section, causing the temperature to get warm, 55 degrees
  • PAUL from WEIRTON, WV
  • Really Easy
  • Less than 15 mins
  • Nutdriver
I followed the procedure online and found the thermostat was ok, it had continuity when cold, and the heater coil was also ok, it too had continuity, therefore the problem was a bad defrost timer. the refrigerator works great, thanks parts select!
Was this helpful?
Thank you for voting!
fridge shut down stopped running
  • robert from Holbrook, NY
  • Really Easy
  • Less than 15 mins
  • Screw drivers, Socket set
simply watched videos provided…making it EXTREMELY simple..saved me hundreds by not having to throw it out!! running better than ever like as if it was brand new!!
Was this helpful?
Thank you for voting!
Freezer & fridge warm / condenser coils iced over
  • Daniel from North Plains, OR
  • Easy
  • Less than 15 mins
  • Screw drivers
Problem not consistent. OK for 2-3 weeks, then freeze coils. Mark and observe the defrost timers manual rotating adjuster. Timer would stop mid cycle. One revolution equals 8 hours of compressor run time followed by 30 minutes of defrost. Replacing timer took 5 minutes.
Was this helpful?
Thank you for voting!
Freezer was cold bit the refrigerator was warm.
  • Christopher from Wilmington, DE
  • Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Based on the diagnosis on this site I thought the 66% odds of the problem being the Defrost Timer looked pretty good, $30 including shipping versus a Sears tech phone estimate of $250-300. BINGO! Just follow the online installation instructions and don't forget to use the reset switch as described. Works like new! THANK YOU
Was this helpful?
Thank you for voting!
Not defrosting and then warm up do to ice
  • Bryan from Red Oak, IA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
replaced the defrosting timer and saved a lot of $ by doing it my self.
Was this helpful?
Thank you for voting!
Freezer Worked Fine, Refrigerator Was 47 Degrees
  • Allan E from Manhattan, IL
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I went on partselect put in make and model number, a list showed the probable cause. I watched the how to video. When I received the part in short order I loosened 2 screws disconnected the wiring plug (sprayed it with contact cleaner) pluged it in, removed screws from old part put them in new one. Put timer back in its location and ti ghtened the screws. Very eazy, works fine.
Was this helpful?
Thank you for voting!
Overheat coils at the bottom inside of the freezer
  • Costas from new hyde park, NY
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I pick up very fast at these kind of small jobs but because of my very busy schedule I decided to call (2 times) technicians about my problem but none of them had any idea. About my repair, I removed the grill at the bottom of the refrigerator, unscrew a small plate (located on the bottom left side) that's holding the defrost timer. I plu g on the new part, screw back the plate with the defrost timer and that was it. Don't forget to turn clockwise with your finger the timer until you hear a "click" and then turn it slightly more to the right. There is also a video on U-tube.
Was this helpful?
Thank you for voting!
fridge side was getting warm.
  • Darryl from Russellville, KY
  • Really Easy
  • Less than 15 mins
  • Screw drivers
open freezer door two screws just below unscrew slide piece to side unplug reinstall very simple.
Was this helpful?
Thank you for voting!
refer quit cooling and so did freezer
  • jerry from petaluma, CA
  • Really Easy
  • Less than 15 mins
I replaced the defrost timer,defrost thermostat,and run cap.as it turned out the compressor went bad. I dont know the model because but the time I got this review I replaced the refer with a knew one . two weeks living out of coolers was so much fun !!!!!!!!
Was this helpful?
Thank you for voting!
Faulty defrost timer. Freezer would not maintain temperature
  • Steve from Nineveh, IN
  • Easy
  • Less than 15 mins
  • Nutdriver
Watched the video once. Removed four 1/4 inch screws with a nut driver unplugged the unit, took out two screws securing the timer. Replaced did all of this in about 10 minutes. It was "exactly" as the video showed and it's worked perfectly since the replacement of the faulty timer. I saved a $75.00 service call minimum and the part was mo re than likely cheaper from Part Select than from the repair facility. Although I'm a pretty good handy man, you would not need any experience to make this repair. The instructions are precise and the part fit perfectly.
Was this helpful?
Thank you for voting!
Refrigerator too Warm
  • Raymond from Yorktown Heights, NY
  • Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
tested the thermostat, cleaned the coils, checked seals all clean. defrost timer did not cycle so replaced it but issue not resolved. even though freezer was working while refrigerator was problematic, proceeded to open freezer panel. discovered that fan was not pushing cold air into refrigerator compartment due to ice build up in conne cting tubes. cleaned ice and replaced panels to positive result
Was this helpful?
Thank you for voting!
Freezer and main compartment had wide temperature variations
  • Joseph from Tullahoma, TN
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I first thought the defroster heater broke - took the back wall of the freezer off and cooling fins were fine. Then took the defroster timer out and opened it up. The contacts were badly burnt so the compressor and fan ran during only part of the cooling cycle. Replacing the timer took less than 5 minutes - turn off the power, remove o ne screw to take out the control box, cut the ground wire (new timer housing is plastic and does not have a ground connection), remove two screws to unmount the timer, unplug the old timer, plug in the new timer, fasten with two screws, put the control unit in and fasten with one screw, turn power back on.
Was this helpful?
Thank you for voting!
All Instructions for the MRT18BRAZ0
106 - 120 of 202