MRT18B Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
gasket needed replaced
3 of 4 people
found this instruction helpful.
-
toney from poplar bluff, MO
- Easy
- 15 - 30 mins
-
Screw drivers
took off the old one installed the new one
Was this helpful?
Thank you for voting!
gasket was deformed; water condensed inside
4 of 7 people
found this instruction helpful.
-
Thomas from Pittsburgh, PA
- Easy
- 15 - 30 mins
-
Screw drivers
a handyman made the repair. It went fine.
Was this helpful?
Thank you for voting!
Water Was Leaking out of Refrigerator
3 of 4 people
found this instruction helpful.
-
Julie from Douglaston, NY
- A Bit Difficult
- 30 - 60 mins
-
Nutdriver, Screw drivers, Socket set
Our old gasket was shot to hell, so we figured we'd replace it to see if that would solve the problem. We followed the instructions of another customer. We realized it was better if we removed the entire door in order to attach the gasket. That took a little doing, but it was totally the way to go. Miracle of Miracles, the leaking has s
... Read more
topped, the food is super cold, and I couldn't be happier.
Read less
Was this helpful?
Thank you for voting!
The refrigerator wasn't cold enough.
3 of 4 people
found this instruction helpful.
-
John from San Diego, CA
- Really Easy
- Less than 15 mins
-
Screw drivers
I removed the plastic shroud on the ceiling of the refigerator, unscrewed and unplugged the old defrost timer, and replaced it with the new one. I reinstalled the shroud with the new timer installed.
Was this helpful?
Thank you for voting!
Evaporator In Freezer Freezing Up, Fridge Warm
3 of 4 people
found this instruction helpful.
-
DONALD from MECHANICSVILLE, MD
- Really Easy
- 15 - 30 mins
-
Nutdriver
Removed shelf brackets to allow the removal of the evaporator sheetmetal cover. Unpluged wires to thermostat ,removed defrost timer and plugged in new timer,(front left lower kick panel). Cut and resoldered wires to new thermostat reinstalled thermostat and cover in reverse order. I knew what parts I needed and how to repair the unit,ho
... Read more
wever your customer comments were spot on and would help anyone perform a successful repair (you provide a helpful service for the public)
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
4 broken drawer cover supports
2 of 2 people
found this instruction helpful.
-
Chester from STOCKTON, CA
- Very Easy
- Less than 15 mins
-
Screw drivers
Followed someone before me instructions. very simple and easy
Was this helpful?
Thank you for voting!
freezer colk, refrig warm
2 of 2 people
found this instruction helpful.
-
Jeff from GLENDORA, CA
- Really Easy
- Less than 15 mins
-
Nutdriver
Followed the instructions provided in your video, took less than 15 minutes and works like new. Thank you for the parts and the advice.
Was this helpful?
Thank you for voting!
Freezer was freezing but refridgerator was warm. Checked fan and it was not turning.
2 of 2 people
found this instruction helpful.
-
Jerry from PHOENIX, AZ
- Really Easy
- 15 - 30 mins
-
Socket set
Unplug fridge. Removed 2 nuts to get the vent plate off and two more nuts to get the motor mount off. Removed fan blade and then the fan motor. I put the new motor in and put everything back as it was. It was very easy. I had items in the freezer, so I didn't turn the fridge off other than to replace the part. It took about 6 hours for t
... Read more
he fridge to reach optional temps because I didn't get to defrost and the fridge had to work it out on it's own. If you don't need the freezer then you should turn the refridgerator off for at least an hour and open the doors so the coils can defrost and any ice blockage between the freezer and fridge portion can melt away as well.
Read less
Was this helpful?
Thank you for voting!
freezing up
2 of 2 people
found this instruction helpful.
-
Kenneth from ADGER, AL
- Very Easy
- 15 - 30 mins
-
Screw drivers
I damaged the timer while moving the fridge and did not realize it and it took 10 minutes to change out. "note" don't panic when it don't come immediately there is a dial in the front of the timer you can turn with a flat head screwdriver that will activate the timer
Other Parts Used:
Was this helpful?
Thank you for voting!
evaporator freezing up/no defrost cycle
3 of 5 people
found this instruction helpful.
-
geoffrey from lawrence, KS
- A Bit Difficult
- 30 - 60 mins
-
Nutdriver, Screw drivers
The defrost timer is faily easy to replace, first unplug the unit, then remove the toe gaurd, then lay on the floor with your light and phillips screwdriver, locate the 2 screws at the lower left side, remove them and the timer and it's shield will drop down. unplug the old timer, plug the new one in and re-install everything. The temp se
... Read more
nsor is located in the back of the freezer compartment. Again make sure the unit is unplugged, remove freezer shelves and lower basket, then with a 1/4" nut driver, remove the screws holding the rear panel on, remove the panel and locate the sensor on the upper evaporator tube, unclip it and disconnect the 2 wires, reverse procedure and plug it back in. Not to get on a soap box, but this is the 3rd time i have had the same problem with this unit, plus several other problems.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
freezer was warm
2 of 2 people
found this instruction helpful.
-
Carol from OSHKOSH, WI
- Easy
- 30 - 60 mins
-
Screw drivers
Top freezer took off the panel in freezer and melted the ice around coils and found the defrost thermostat and replaced with the new one. Just followed the instructions from your video on line. Freezer works just fine now. Refrigerator is 38 years old.
Was this helpful?
Thank you for voting!
The original fan motor began masking a noise and finally stoped working.
2 of 2 people
found this instruction helpful.
-
Justin from FRANKLIN, TN
- Easy
- 30 - 60 mins
-
Nutdriver
Followed video instruction and completed the replacement. I had to join the wires since the connector was a male plug to a make plug.
Was this helpful?
Thank you for voting!
Fridge not cooling
3 of 5 people
found this instruction helpful.
-
WESTLEY from HATTIESBURG, MS
- Easy
- 15 - 30 mins
-
Nutdriver
My fridge side had warmed up to 70 degrees but the freezer side was still cold. The coils inside had iced up. After thawing with a hair dryer, it froze back after another week. I removed the old defrost thermostat and wired the heater strip directly and turned on the defrost timer. It began melting the ice so that ruled out the heate
... Read more
r strip being bad. I couldn't get a reading with my ohm meter on the defrost thermostat so I took a chance and bought the part. Installation was a breeze and it fixed the problem.
Read less
Was this helpful?
Thank you for voting!
The freezer coils were frosting up
3 of 5 people
found this instruction helpful.
-
David from Seattle, WA
- Easy
- 15 - 30 mins
-
Nutdriver
Removed the back panel of the freezer. Unplugged the defrost cycle thermostat and replace with a new one.
Removed the bottom cover in front of the refrer. removed the defrost timer, plugged new timer in. manually tripped the defrost timer. checked the defrost heater for operation. Checked OK, replaced covers, works like a champ
Removed the bottom cover in front of the refrer. removed the defrost timer, plugged new timer in. manually tripped the defrost timer. checked the defrost heater for operation. Checked OK, replaced covers, works like a champ
Other Parts Used:
Was this helpful?
Thank you for voting!
refrigerator coil frozen up and kept the refrigerator from cooling
2 of 2 people
found this instruction helpful.
-
Shannon from Bluefield, WV
- Really Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers
Remove front cover below door, remove 2 screws attaching the defrost timer to the refrigerator frame.
Unplug wiring harness plug from timer an install new one.
Remove metal cover in back of the freezer compartment. unpug the two wires going to the thermostat, remove the thermostat { thermostat is held onto the cooling coil with ... Read more a clip} , remove thermostat and replace with new one
Unplug wiring harness plug from timer an install new one.
Remove metal cover in back of the freezer compartment. unpug the two wires going to the thermostat, remove the thermostat { thermostat is held onto the cooling coil with ... Read more a clip} , remove thermostat and replace with new one
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!