MRT13CRE Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Fridge not cooling
3 of 5 people
found this instruction helpful.
-
WESTLEY from HATTIESBURG, MS
- Easy
- 15 - 30 mins
-
Nutdriver
My fridge side had warmed up to 70 degrees but the freezer side was still cold. The coils inside had iced up. After thawing with a hair dryer, it froze back after another week. I removed the old defrost thermostat and wired the heater strip directly and turned on the defrost timer. It began melting the ice so that ruled out the heate
... Read more
r strip being bad. I couldn't get a reading with my ohm meter on the defrost thermostat so I took a chance and bought the part. Installation was a breeze and it fixed the problem.
Read less
Was this helpful?
Thank you for voting!
The freezer coils were frosting up
3 of 5 people
found this instruction helpful.
-
David from Seattle, WA
- Easy
- 15 - 30 mins
-
Nutdriver
Removed the back panel of the freezer. Unplugged the defrost cycle thermostat and replace with a new one.
Removed the bottom cover in front of the refrer. removed the defrost timer, plugged new timer in. manually tripped the defrost timer. checked the defrost heater for operation. Checked OK, replaced covers, works like a champ
Removed the bottom cover in front of the refrer. removed the defrost timer, plugged new timer in. manually tripped the defrost timer. checked the defrost heater for operation. Checked OK, replaced covers, works like a champ
Other Parts Used:
Was this helpful?
Thank you for voting!
Freezer wasn't cooling - compressor not engaging
2 of 2 people
found this instruction helpful.
-
Judy from ROYSE CITY, TX
- Really Easy
- 30 - 60 mins
Ordered the Capacitor and the Thermostat Control. Parts were received in a matter of a few days, easy to install, but did not fix the problem. Had to call a repairman to fix the problem (compressor relay - this part not available to order for this model number with Parts Select). Will continue to use Parts Select in the future for other p
... Read more
arts, but not happy that the actual part I needed was not available - had to use other methods.
Read less
Was this helpful?
Thank you for voting!
refrigerator coil frozen up and kept the refrigerator from cooling
2 of 2 people
found this instruction helpful.
-
Shannon from Bluefield, WV
- Really Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers
Remove front cover below door, remove 2 screws attaching the defrost timer to the refrigerator frame.
Unplug wiring harness plug from timer an install new one.
Remove metal cover in back of the freezer compartment. unpug the two wires going to the thermostat, remove the thermostat { thermostat is held onto the cooling coil with ... Read more a clip} , remove thermostat and replace with new one
Unplug wiring harness plug from timer an install new one.
Remove metal cover in back of the freezer compartment. unpug the two wires going to the thermostat, remove the thermostat { thermostat is held onto the cooling coil with ... Read more a clip} , remove thermostat and replace with new one
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
The original fan motor began masking a noise and finally stoped working.
2 of 2 people
found this instruction helpful.
-
Justin from FRANKLIN, TN
- Easy
- 30 - 60 mins
-
Nutdriver
Followed video instruction and completed the replacement. I had to join the wires since the connector was a male plug to a make plug.
Was this helpful?
Thank you for voting!
freezer was warm
2 of 2 people
found this instruction helpful.
-
Carol from OSHKOSH, WI
- Easy
- 30 - 60 mins
-
Screw drivers
Top freezer took off the panel in freezer and melted the ice around coils and found the defrost thermostat and replaced with the new one. Just followed the instructions from your video on line. Freezer works just fine now. Refrigerator is 38 years old.
Was this helpful?
Thank you for voting!
evaporator freezing up/no defrost cycle
3 of 5 people
found this instruction helpful.
-
geoffrey from lawrence, KS
- A Bit Difficult
- 30 - 60 mins
-
Nutdriver, Screw drivers
The defrost timer is faily easy to replace, first unplug the unit, then remove the toe gaurd, then lay on the floor with your light and phillips screwdriver, locate the 2 screws at the lower left side, remove them and the timer and it's shield will drop down. unplug the old timer, plug the new one in and re-install everything. The temp se
... Read more
nsor is located in the back of the freezer compartment. Again make sure the unit is unplugged, remove freezer shelves and lower basket, then with a 1/4" nut driver, remove the screws holding the rear panel on, remove the panel and locate the sensor on the upper evaporator tube, unclip it and disconnect the 2 wires, reverse procedure and plug it back in. Not to get on a soap box, but this is the 3rd time i have had the same problem with this unit, plus several other problems.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Frost in freezer, fridge not cold
2 of 3 people
found this instruction helpful.
-
Bob from Pinole, CA
- A Bit Difficult
- 30 - 60 mins
From most posts I've read, the defrost timer was the culprit so I blindly ordered one. Easy install but did not fix the problem so I broke out the ohm meter. The only other 2 items it could be all tested good with my meter so I bypassed the defrost thermostat (per forum help...actually quite easy)and it defrosted fine, which told me I nee
... Read more
ded a new defrost thermostat. Installed fairly easy and problem gone.
Read less
Was this helpful?
Thank you for voting!
Drain pan for refrigerator
3 of 6 people
found this instruction helpful.
-
Lynda from Rocky Point, NY
- Difficult
- 1- 2 hours
-
Pliers, Screw drivers
Took old defrost pan off, put new one on. Had to bend new defrost pan a little for it to fit..
Was this helpful?
Thank you for voting!
Cooling coils would ice up and fridge would warm up
2 of 3 people
found this instruction helpful.
-
Richard from Tehachapi, CA
- Really Easy
- 15 - 30 mins
-
Nutdriver
I removed the shelves in the freezer, took out the five 1/4" screws and lifted off the cover. It was a simple matter of using a blow drier to remove all the ice, then unplugging the two wires and unclipping the thermostat from the upper cooling tube. Then clipped the new one on and reconnecting the two wires.
Works great!!!
Works great!!!
Was this helpful?
Thank you for voting!
Refrigerator was not cooling and the motor was running constantly
2 of 3 people
found this instruction helpful.
-
Anil from Somerset, NJ
- Really Easy
- 15 - 30 mins
-
Nutdriver, Pliers
Having tried PartSelect.com before, I was very comfortable with the process. Input my symptoms and the feed back I received was that one of the 2 things (Defrost Timer or Defrost Thermostat)might need replacement. Since the cost was not much and over night shipping would cost more than the product, I decided to order both the parts. Chang
... Read more
ing parts was a breeze. The instructions posted by others on your web site were very easy to follow. You guys save me a bundle every time I have any thing going worng with any of my appliances.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Freezer frozen, refrigerator warm
2 of 3 people
found this instruction helpful.
-
Janet from Stockbridge, MI
- Easy
- 15 - 30 mins
-
Nutdriver
removed the screws/nuts; pulled the back panel off, removed the old thermostat (wires just popped apart) replaced the new thermostat (wires just popped back on) replaced the back panel and the nuts and TaDa!!
Was this helpful?
Thank you for voting!
the refrig was in storage for about a year, the freezer door warped
3 of 6 people
found this instruction helpful.
-
Jeffery from Phillipsburg, NJ
- Really Easy
- Less than 15 mins
removed freezer door and installed the new one. This was a pretty easy thing to do, although putting the old handle on the new door was a challenge. No knowing that there is a plastic piece holding the top of the handle i broke the that piece and had to order another one. Mean while the freezer was making alot of frost inside, so that
... Read more
had to be cleaned after the new part came.
Read less
Was this helpful?
Thank you for voting!
the freezer would stick in defrost and not come out
2 of 3 people
found this instruction helpful.
-
carol from woodland, WA
- Really Easy
- Less than 15 mins
-
Screw drivers
Removed the vent cover at the bottom. Removed the screws. disconected the harnes and put the new timer in. This was a very easy fix. Thank You!
Was this helpful?
Thank you for voting!
first fresh food too hot, then freezer too hot
2 of 3 people
found this instruction helpful.
-
Rita from Lake Luzerne, NY
- Really Easy
- Less than 15 mins
-
Nutdriver
Based on the website I decided it was most probably the defrost timer, and that was correct. I ordered it, watched the video, and two days later the part was at my door. Took the nut driver, removed 4 screws, then removed the old defrost timer, installed the new one, re-installed the whole plastic assembly with the four screws, and done
... Read more
!!! Couldn't have been easier.
Read less
Was this helpful?
Thank you for voting!