MHE11REQ0 Roper Microwave - Parts

This 40w light bulb is a replacement bulb constructed of glass and metal. It is an easy-to-install electrical part which produces 40w of light. If the bulb won't light up then it may be broken and should be replaced. The bulb attaches directly to an appropriate light socket and has a small screw-in base. To access the exterior light bulb,...Read more you will need to remove the panel on the bottom of the microwave using a Phillips screwdriver. If your exterior light bulb has not been changed before, it is probably held in place with some silicone. You will need to cut away this silicone to remove the old bulb. If you cannot access the silicone with a utility knife, it can be removed using dental floss. Once the silicone is removed, simply unscrew the old bulb, and replace it with the new one. Be sure to disconnect the power to the microwave before you begin this repair. This light bulb measures about 1 1/8 inches. We do not recommend using a higher-wattage bulb for this appliance, and can only recommend this specific bulb. If fixing the bulb does not solve your microwave light issue, it's possibly a problem with the socket, which means the socket and/or board will need to be replaced. This can be a more dangerous repair, so consult your user manual or a technician before attempting.

This is a vent hood grease filter manufactured for a variety of microwave models. It is made entirely of metal with a built-in tab for easy installation and removal. The vent hood filter collects grease particles that are in the exhaust air from cooking. Be sure to keep your filter clean. A clogged or dirty filter is a fire hazard and can...Read more cause your appliance to run inefficiently. This filter is approximately 7.5 inches wide and 5 inches deep. This replacement part is a genuine OEM part, is sourced from the original manufacturer, and is sold separately.

This screw is sold individually.

Sold individually.

This part is a genuine manufacturer door interlock switch kit, also known as primary micro switch or microwave switch kit, for a microwave. The function of this part is to sense when the door of the microwave is open or closed. If the part is defective, the microwave will not start or will start when door is open. This kit contains two 15...Read more Amp, 125/250 Volt switches with 3/16 inch terminals. Be sure to disconnect power to microwave before replacing part. Use extreme caution when replacing microwave parts, as high-voltage capacitors can retain an electrical charge when unplugged. NOTE: This kit includes 2 single pole, double throw (SPDT) micro switches. As per the manufacture for the secondary interlock switch order part # 56001100.

Sold individually. For white and almond models.

Glass only.

Sold Individually.

This tapping screw is sold individually.

This black vent grille vent mounts on the top of the microwave above the door.

This screw is sold individually.