MDB4949SKZ1 Maytag Dishwasher - Instructions

I called an experienced plumber, who balanced and installed my new dishwasher properly, using the brackets I ordered from Parts Select, after an INEXPERIENCED plumber had tossed the factory-provided mounting brackets out with the shipping carton. Relief!

The valve has a plastic fitting to attach the the water line with a hose fitting. Was not carful enough with the original and damaged it attaching the water line. Ordered a replacement fitting. While it is possible to replace the water inlet valve without pulling the dishwasher out from the cabinet found it was easier to get at with the m ... Read more achine out. The video does and good job of showing the removal and replacing the valve. Easy job, don't be like me and be careful attaching the water line.

I searched for another dishrack that was compatible with our unit. After measuring and searching online I found Partselect website and placed the order. It was a very easy process. I bought the rack without wheels and just removed the ones from our current bottom rack and put them on the new rack.

After unplugging the dishwasher, removing the water supply hose, and disconnecting the drain hose, I removed the dishwasher from under the cabinet. I turned the dishwasher on its side, exposing the drain pump. I removed the electrical connection wire by sliding the white keeper forward and then using a small screwdriver, I pushed in on ... Read more the black clip securing the plug. I then found the clip holding the pump and rotated the pump from the sump area. I installed the new pump in the same way I removed it. Reinstalled the water line, pump hose . Put unit back and plugged it in. Turned on dishwasher. Works perfectly now.

I found it best to lay the dishwasher on it's side, this makes it easier to attach a 90 degree hose fitting without cross threading the plastic fitting.

Removed old part and replaced with new part

Cut DW brackets to size, attached to DW. Bent back tabs, pushed DW into place and installed screws.

Pulled the dishwasher out. Located the drain pump. Removed it. Identified the problem (broken tines).
Replaced pump as described in available video. Repositioned dishwasher. Ran test.

followed directions, a kid could have done it,

It’s great when you have parts that fit and a schematic to go by. I got both from this site. There are three parts that these screws hold in place. Use the schematic to see which way each part is facing. Line all the parts up and then look through the covers. You’ll see pre drilled holes on either side of the cover. Line the screws up to ... Read more the pre drilled holes. Put the first screw in half way then insert the second screw all the way. Come back to the first screw and tighten it all the way. Two screws, two minutes and I was done. Real easy repair, just awkward as you are on your belly on the floor. I used a drill with a socket that fit the screw head.

I just popped the new one onto the bottom of the middle rack and it was done. Easiest repair I have EVER done!

Very simple repair when you're supplied with the proper parts. Their delivery time is exceptional !

Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!

I put this unit in about 3 years ago and the brackets broke at the crease and the dishwasher fell forward. Found the right bracket and when it arrived looked a match. Checked link to video showing how to properly install the brackets. The original manufacturer never stated that the tab that goes through the frame is supposed to be bent 90 ... Read more degrees to prevent the bracket from coming out. Thank you PartSelect for that video because I would probably end up ordering brackets again in a few years.

I simply disconnected the power line to the dishwasher and pulled it out enough to install the mounting brackets. The installation manual that came with the dishwasher described how to install the brackets and I simply followed directions.