LS14 Makita Miter Saw - Parts

This authentic OEM sourced replacement part is specially designed for use with Makita power tools. Ball bearings are generally utilized to reduce the friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Over time components...Read more may wear out and begin to fail eventually requiring a replacement, keep in mind this high-quality metal bearing is sold individually.

This is a replacement part directly sourced from the manufacturer. O-ring is made of black rubber, and is compatible with many Makita rotary hammers, miter saws and nailers. It is recommended to refer to the tool manual for specific replacement instructions. A screwdriver is often needed to make the necessary removal and replacement of this part. This item is sold individually.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling O-rin...Read moreg has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.