LS10 - Parts

This switch activator button is a genuine Makita replacement part, It is sold individually. It has to be pressed to activate the power switch. This is a very common replacement part. It is advised to order one or two extra to keep on hand. This Makita switch button is compatible with the tools listed below, and it is not guaranteed to fit any other power tool models.

This is a genuine Makita replacement part that includes two carbon brushes with wire leads attached. Carbon brushes are essential components in power tools and are among the most commonly replaced parts due to regular wear from friction. Over time, worn brushes can cause a motor to run poorly, operate intermittently, or lose electric brak...Read moreing power. Replacing them can often restore your tool’s performance. A worn brush may appear cracked, pitted, burned, or worn down near the wire lead. It’s always best to replace both brushes at the same time, even if only one shows signs of wear. When installing new brushes, be sure to inspect the armature for any damage such as burns or cracks, which could indicate more serious motor issues.

This genuine Makita replacement part is designed for use with a variety of power tools. This screw is a standard hardware which has multiple applications based on your tool. It is made out of metal and it is sold individually. Would require a screwdriver to install or remove this screw.

This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Over time, power tool cords will wear out or become frayed. We recommend replacing a cord as soon as signs of wear are visible. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 8 Feet Long

This replacement pin is an authentic OEM component which is made for use with Makita equipment. The pin is generally utilized to secure a part while allowing it to rotate freely. It is a standard hardware which may have multiple applications. Make sure to refer to the appropriate diagrams of your model for the exact location and the corre...Read morect installation of this pin. One durable metal item is included. You may need a screwdriver to take the unit apart when replacing this pin.

This is a genuine OEM replacement part sourced directly from manufacturer. It is connected to the arm holder and it allows you to lock the saw in the needed position. This lever is made out of black plastic and it is sold individually. You would need a screwdriver to remove the screw that secures this lever.

This is an authentic manufacturer approved replacement cover designed for use with Makita miter saws. It ensures users safety when the saw is in operation. It is made out of clear plastic and it is sold individually. Replacing this part is relatively easy you would only need snap-ring pliers and a hex key/allen wrench to complete the job...Read more. • First you would need to take off the blade by removing the blade screw • Then remove the retaining ring that holds the guard on • Remove the retaining ring (note how the ring is installed) and take off the old guard • Install the new guard

This is an authentic manufacturer sourced replacement part used on Makita compound miter saws. Kerf boards (also called kerf plates) are used to prevent excessive splintering, resulting in cleaner cuts. Using the wrong kerf board for your tool can give a rough edge to the material you're cutting. This part is made out of plastic and it is sold individually. Screws that attach this part are sold separately.