This refrigerator water filter is designed to improve the taste and odor of both water and ice by reducing a wide range of contaminants. Utilizing an activated carbon block filtration method, it effectively captures impurities such as lead, chlorine, mercury, cysts, asbestos, and particulates, while allowing fluoride to pass through. The ...Read morefilter is certified to meet NSF/ANSI Standards 42 and 53 for water purification, ensuring reliable performance and safety. With a lifespan of approximately six months or 300 gallons—depending on water quality and usage—it provides consistent filtration and supports the overall efficiency of your refrigerator’s water system.
This part is the replacement water line for your refrigerator. It is a long plastic tube, which is 5/16 of an inch in diameter. If your refrigerator is leaking, or if it will not dispense water or ice, you may have a damaged water line. When you replace the water line, you may want to pick up a new water tube union as well. You can use a ...Read moreutility knife to cut the old water line where it is damaged, and use the union to attach the new water line to the old one. This tubing is sold individually and is an OEM part.
This part is the replacement ice tray for your refrigerator. The tray is made of white plastic and is approximately 9 inches in length, and 3 inches in width. It has the capacity for 8 ice cubes. The ice tray can be filled up with water and is the mold that shapes the ice cubes. If your current ice tray is cracked, warped, or if mineral d...Read moreeposits have settled inside it, it may cause the ice cubes to stick. This part is sold individually and is an authentic OEM part.
This heated ice chute door helps prevent ice buildup and sticking by gently warming the chute opening during dispensing. Designed for smooth, reliable ice delivery, it restores proper operation when ice jams or blockage occur.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The ice tray had warped and dumped water, which then froze down through the ice bucket and below.
8 of 8 peoplefound this instruction helpful.
George from ATLANTA, GA
Easy
Less than 15 mins
Screw drivers
To replace the warped tray, I found the service manual (pg. 124 below) which took some interpreting. Removed the lever. Then removed the assembly by two screws that are forward to the unit and go upwards. The insulation, sensor, and sensor cover are simply pulled down and off and the unit separated to removed the tray, and
... Read morethen insert the new tray. Proceed in reverse. Takes only a few minutes.
/Users/grf/Desktop/fridge ice tray.pdf
Read less
Was this helpful?
Thank you for voting!
Ice dispenser door didn't close
7 of 12 peoplefound this instruction helpful.
Wesley from WILTON, NH
Very Easy
15 - 30 mins
Screw drivers
I replaced solenoid, flapper heated door, and broken spring. Very easy instructions on "YouTube"
Was this helpful?
Thank you for voting!
The rails for one of drawers were replaced
5 of 8 peoplefound this instruction helpful.
Michael G, from CENTENNIAL, CO
Really Easy
Less than 15 mins
Removed old rails and tapped new rails in place. The big problem was finding how to fix the drawer. After searching many online websites, It was my good fortune to find Partselect and a one of their service representatives who knew how to fix my drawer and they had the part.