LP25937 Murray Snow Blower - Parts

It is an authentic OEM sourced item which is specially produced for use with Murray, Snapper, and Simplicity snowthrowers. The axle bearing fits between the axle shaft and the flatwasher and helps to reduce friction. During the installation process, a screwdriver and a wrench set might be needed to replace this part. It may become broken ...Read moreand will need to be replaced. This is made of metal and is available as an individual replacement part.

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.

This is a genuine OEM sourced replacement hardware designed for use with snowblowers. Shear bolts are installed in order to protect your unit. If the auger gets jammed or clogged, shear bolt is designed to snap at a certain point of pressure, so it will not damage any other part of the unit. It is made from metal and it is sold individually. You will need a wrench to remove or install this bolt.

This flange nut is designed for use in lawn and garden equipment. It is an OEM replacement part with a diameter of 0.375 inches and a thread pitch of 16 threads per inch. The nut has a ring-shaped extension on one end, known as a flange which helps to evenly distribute the clamping force of the nut and provide a more secure hold. Addition...Read moreally, the flange eliminates the need for separate washers and reduces the risk of abrasion on the surface being fastened. It is normal for the nut to corrode, crack, or for the threads to wear down over time. To replace the flange nut, unthread it from the fastener, and insert and secure the new one using a socket/wrench. Each sold individually.

Control cable front drive

This is an authentic manufacturer-sourced replacement flat washer which is specially produced for use with Murray lawn and garden equipment. It helps to distribute the pressure evenly between connected pieces, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. This high-quality metal washer is sold individually.

This OEM universal joint pin is used within various models of snowblowers to hold the rod and yoke together inside the deflector/chute assembly. If you notice excessive vibrations, clunking, or limited range of motion within the chute mechanism, it is worth inspecting to check for a broken pin or other internal damage. To prevent any futu...Read morere issues with your universal joint pin, make sure to keep it adequately clean and lubricated and inspected regularly. This pin is made of a high-quality metal, measures 1-inch long and .375-inches thick, and is sold as an individual part.

The washer goes between the bearing and the intermed sprocket. It is available as an individual replacement part. This item is an OEM from Murray, Snapper, and Simplicity for use in snowblowers. A wrench might be needed during the installation process. It is made of metal and will require replacing if it bends or breaks.

Spring ext idler 8-13

A genuine item which is supplied directly from the original equipment manufacturer for use with Murray and Snapper lawn and garden equipment. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check the appropriate diagrams for the correct location and use of this screw. Keep...Read more in mind this high-quality component is made of durable metal and is sold individually.

This is a genuine Murray, Snapper, and Simplicity part sourced directly from the manufacturer for use in snowthrowers. The clutch spring boot is made out of rubber. A set of pliers may be necessary during the installation of this item. It may become broken and will need to be replaced. This is available as an individual replacement part.