LP25936 Murray Snow Blower - Parts

This is a genuine OEM sourced replacement hardware designed for use with snowblowers. Shear bolts are installed in order to protect your unit. If the auger gets jammed or clogged, shear bolt is designed to snap at a certain point of pressure, so it will not damage any other part of the unit. It is made from metal and it is sold individually. You will need a wrench to remove or install this bolt.

This is a genuine manufacturer-approved item that is specially designed for Craftsman snowblowers. It is an identical replacement for a missing or damaged knob that was originally installed on a new unit. The purpose of this component is to provide a user with a comfortable grip to secure the adjusting chute. Please make sure to refer to ...Read morethe appropriate diagrams of your model for the exact location and the correct installation of this component. Keep in mind this durable plastic knob is sold individually.

Control cable front drive

This is an authentic manufacturer-sourced replacement flat washer which is specially produced for use with Murray lawn and garden equipment. It helps to distribute the pressure evenly between connected pieces, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. This high-quality metal washer is sold individually.

The oil seal goes between the gear case and the flange bearing. This authentic item is supplied directly from the original equipment manufacturer for use with snowblowers made by Murray and Simplicity. The part is sold individually and is made of metal and rubber. A screwdriver might be helpful during the installation of this part. It will need to be replaced if it breaks or loses its seal.

This is a genuine Craftsman replacement part that is sourced from the original manufacturer to be used with snowthrowers. The metal hex nut is commonly used to fasten the bolt that secures the height skid to the auger housing. This item is available as an individual replacement part, please note four nuts may be required.

This is an authentic OEM sourced part which is specially designed for use with Craftsman snowblowers. It is an identical replacement for a missing or faulty worm gear that helps to drive the auger shaft and has a key slot in the arbor to fit onto the output shaft using a woodruff key which is sold separately. Keep in mind this high-qualit...Read morey component is made of durable metal and is sold individually. Please make sure to check the appropriate diagrams of your model for the correct location and application of this part.

A genuine OEM supplied replacement part that is specially designed for use with Craftsman snowblowers. This is the special transmission belt that helps to drive the unit, please make sure to check appropriate diagrams of your model for correct location and use of this item. Over time due to normal use belts tend to wear out and stretch ev...Read moreentually requiring replacement to keep your equipment running at peak level. It is made of durable rubber material and it is sold individually.

Used to hold a shaft with a mating part, such as a gear, this Woodruff Key is sourced directly from the original manufacturer, is made of metal, is grey, and is sold individually, not as part of a kit or assembly. When this part becomes broken or damaged, it should be replaced. You may notice the mating shaft or gear will no longer rota...Read morete together if the part is malfunctioning. Customers rated this repair as Easy.

This OEM universal joint pin is used within various models of snowblowers to hold the rod and yoke together inside the deflector/chute assembly. If you notice excessive vibrations, clunking, or limited range of motion within the chute mechanism, it is worth inspecting to check for a broken pin or other internal damage. To prevent any futu...Read morere issues with your universal joint pin, make sure to keep it adequately clean and lubricated and inspected regularly. This pin is made of a high-quality metal, measures 1-inch long and .375-inches thick, and is sold as an individual part.

The washer goes between the bearing and the intermed sprocket. It is available as an individual replacement part. This item is an OEM from Murray, Snapper, and Simplicity for use in snowblowers. A wrench might be needed during the installation process. It is made of metal and will require replacing if it bends or breaks.