My Orders
- Home
- LFTR1835VF7
- Instructions
LFTR1835VF7 Electrolux Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Fridge started making a loud racket. Condenser Fan Blade then disintegrated to dust and pieces. The plastic had degraded significantly.
4 of 7 people
found this instruction helpful.
-
Jack from WALLING, TN
- Really Easy
- 15 - 30 mins
-
Nutdriver, Socket set
The repair itself total time was quick and easy. Since the original fan blade blew apart, it was only a matter of putting the new one on in it's place. This can be done by feeding the blade between the cowling and Condenser coil and applying pressure to get it on the shaft.
If your fan is still on the shaft, simply push it off ... Read more and extract it the same way. Then place the new one on the shaft.
In my case, since the part would take a couple days to get, and I had food both in the fridge and the freezer, I removed and unplugged the Condenser Fan Motor and the cowling frame and temporarily spliced a small fan I had into the line for the condenser motor. This kept the fridge working long enough to get the replacement part.
Side note. Direction of airflow is towards the Compressor, and draws air across the Condenser coils.
Hope this helps someone. :)
If your fan is still on the shaft, simply push it off ... Read more and extract it the same way. Then place the new one on the shaft.
In my case, since the part would take a couple days to get, and I had food both in the fridge and the freezer, I removed and unplugged the Condenser Fan Motor and the cowling frame and temporarily spliced a small fan I had into the line for the condenser motor. This kept the fridge working long enough to get the replacement part.
Side note. Direction of airflow is towards the Compressor, and draws air across the Condenser coils.
Hope this helps someone. :)
Read less
Was this helpful?
Thank you for voting!
One blade broke from condenser fan
12 of 32 people
found this instruction helpful.
-
Chris from Lockport, NY
- Really Easy
- Less than 15 mins
The part i recieved, from parts select was a larger in circumfrence (<1/4) than the original. However i was not aware of this until after i treid to repair it.
I removed the broken fan from the condenser. This was very sipmle.
When i pluged the refridgerator back in to the outlet the fan tried to start up but soon be ... Read more gan to make aloud noise, due to there not being enough clerance.
I removed the broken fan from the condenser. This was very sipmle.
When i pluged the refridgerator back in to the outlet the fan tried to start up but soon be ... Read more gan to make aloud noise, due to there not being enough clerance.
Read less
Was this helpful?
Thank you for voting!
Removed ice maker
2 of 7 people
found this instruction helpful.
-
Edward from St. Petersburg, FL
- Very Easy
- Less than 15 mins
Removed ice maker because it wasn't being used. Line Cover up and it snaps right in.
Was this helpful?
Thank you for voting!
The new motor mount screw holes were not threaded.
1 of 5 people
found this instruction helpful.
-
Greg from henrico, VA
- A Bit Difficult
- 1- 2 hours
-
Nutdriver, Socket set
I had to tap the screw holes with a 8/32 tap so that the screws would not bind.
Was this helpful?
Thank you for voting!
bulb burned out
17 of 62 people
found this instruction helpful.
-
Jack from SILVER SPRING, MD
- Really Easy
- Less than 15 mins
replaced bulb
Was this helpful?
Thank you for voting!