My Orders
- Home
- KXW8748YSS0
- Instructions
KXW8748YSS0 KitchenAid Range Hood - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
one switch went out on the range hood controlling the lights.
3 of 3 people
found this instruction helpful.
-
Jeffrey from MILTON, FL
- Very Difficult
- More than 2 hours
-
Screw drivers
The repair did not happen. Parts select sent me the wrong part. They sent a cover plate without any switches.
I;m still waiting for the correct part.!!!!!!!!!!!!!!!!!!!!!!
I;m still waiting for the correct part.!!!!!!!!!!!!!!!!!!!!!!
Was this helpful?
Thank you for voting!
SWITCH CONTROL UNIT HAD BROKEN OFF FROM ONE END OF ITS INTERIOR MOUNTING
2 of 3 people
found this instruction helpful.
-
NICHOLAS & LEIGH from CHARLOTTE, NC
- A Bit Difficult
- 1- 2 hours
-
Screw drivers
Removed and cleaned to overhead grease trap filters which required a sink full of detergent some wire wool pads and and much elbow grease. This is probably a service task that should be performed at least annually for hoods in frequent use. And be careful not to cut your fingers on some of the sharp interior edges.
With the g ... Read more rease filters removed it was then possible to access the switch unit from the inside of the hood. Used a small Phillips screwdriver to loosen and remove the two fastening screws and removed and replaces the whole unit.
Refitting was the reverse of the above process.
With the g ... Read more rease filters removed it was then possible to access the switch unit from the inside of the hood. Used a small Phillips screwdriver to loosen and remove the two fastening screws and removed and replaces the whole unit.
Refitting was the reverse of the above process.
Read less
Was this helpful?
Thank you for voting!
Control panel broken
1 person
found this instruction helpful.
-
Brian from LEANDER, TX
- Very Difficult
- More than 2 hours
Amazing. PartSelect shipped me the wrong part and then wouldn't refund shipping cost to return it. They need to change their shipping policy as it now states they refund shipping if they were the cause of the mistake.
Was this helpful?
Thank you for voting!