KUDP02F KitchenAid Dishwasher - Parts

Sold individually.

This housing comes in two pieces, and with two screws.

Sold Individually.

Supplies water from the main water feed tube to the middle manifold water tube.

This is the replacement impeller kit for your dishwasher. This impeller kit comes with 4 pieces, including the impeller and seals which you will need for the repair. The impeller and seal kit is mounted on the dishwasher motor. If your dishwasher is not cleaning dishes properly, it may be an indication that your impeller has gone bad, and...Read more you are not getting proper water pressure. If the seals have gone bad, your dishwasher may start to leak. If you are having either of these problems, you may need to replace the impeller kit. Be sure to disconnect the water and power source from the dishwasher before you begin this repair. This is an OEM part sourced directly from the manufacturer.

This part is used with the lower spray arm.

Measures level of soil in the water.

Water is supplied to the lower spray arm via the pump assembly.

This board is located in the control panel of the dishwasher.Thermal fuse is NOT included.

Sold individually.

A rusty or bent upper rack can make dishes hard to load and may block proper washing. The open wire frame holds smaller dishes while water moves around them. First check the wheels, adjusters, rail stops, spray arm, and clips for wear because they must be reused or ordered apart. Match the bare rack to the complete appliance model. Remove...Read more all dishes, support the rack while sliding it from the rails, and note where each attachment fits. After moving the parts, make sure the rack rolls smoothly and cannot slide off the tracks.

Light gray in color.