KUDK01 KitchenAid Dishwasher - Parts

This part releases the detergent and rinse aid into the dishwasher.

This spring is located in the door section. Sold individually.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve will open and close according to the desired amount of water needed.

This lower dishrack is a genuine replacement component designed for select Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Inglis, and Magic Chef dishwashers. Manufactured for durability and optimal performance, it securely holds plates, bowls, and other dishware during wash cycles. The rack is finished in gray, though the shade may vary ...Read moreslightly, and does not include rollers, which must be transferred from the original rack. Installation is straightforward and can be completed using basic hand tools, provided the dishwasher is disconnected from power and water sources. This replacement is ideal for racks that are cracked, rusted, peeling, or stained, helping restore both functionality and appearance.

This part is the top spinner located at the very top of the wash tub. Water passes through all the spinners causing it to dispense all around the tub.

This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air conditioners. This clamp is used to securely attach a hose to another part of your appliance, which helps prevent leaks from those connections. Depending on th...Read moree appliance, it can attach hoses to drain pumps, water inlet valves, pressure switches, and injector nozzles. We recommend you refer to model-specific diagrams for appropriate uses and exact placement. This hose clamp is made of metal, and is sold individually. To access and replace this part you will need a nut driver, pliers, and screwdrivers. Before you begin any repair work, make sure you have unplugged your appliance, and shut off the water supply if applicable.

The circulation pump and motor is located near the bottom of the dishwasher. The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle. Before you begin this repair, it is recommended that you pull your dishwasher out of the cabinet, so you can tip the...Read more dishwasher to one side and gain better access to the circulation pump and motor. Be sure to disconnect the power source and the water source to the dishwasher before you begin this repair. To complete this repair you will need a 1/4 inch nut driver and a 3/8 inch nut driver.

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

This is a seal, but you may also know it as a door gasket and it is for your dishwasher. The seal forms a watertight barrier between the door and the dishwasher tub, deterring water from escaping during a wash cycle. If your dishwasher is leaking you will need to replace the seal, as it is likely damaged. The first step should be to check...Read more the seal for buildup of food particles near the sides and the bottom of your appliance.

This seal is located between the spray arm and the water feed tube.

Also known as a wash arm seal.

Sold individually.