KUCS181D0 KitchenAid Trash Compactor - Instructions

Since the belt broke, I had to put the cogged belt on the large driven pulley first, after loosening the four motor mount screws, and sliding the motor as close to the driven belt as I could. After several tries, I positioned the belt successfully on the driven pulley, then slipped it over the pulley on the motor. I pulled the motor as fa ... Read more r away from the driven pulley to put proper tension on the belt without being excessive. I snugged the four motor mount bolts, tested the compactor and after a successful run, tightened the bolts on the motor mount. I then replaced the latch assembly, two screws and it was done.

Jimmied out the latch using two screw drivers to get under the edges. Pushed the new piece in. Voila! Took 2 minutes for what my repair man told me would cost about $200 to fix. Unbelievable!!( I first watched some YouTube videos to get the idea )

I Removed The Back Panel To Get At The Top Panel Which In Turn I Got To Top Plate To Access The Gear Drive, The Ram Was In The Down Position So I Used a Socket And Rachet To Crank The Ram Up By Hand, I Then Loosened The Plastic Gear Mount To Move The Gear Forward To Attach The New Belt, Then Reversed The Procedure putting The Campactor In ... Read more operating Condition And It Work's Great

I take the screws out of the door, I removed the catch from behind inside the dryer door, I slid the new catch in the door and snapped it in place. After getting a new catch in the door I put the door back together and put the screws in. Easy repair

just replaced parys

The only thing I had to do was hammer the catch inside the square fitting and presto it was done. It took me less than 3 mins. I thought I might of needed instructions, but it was really simple. Even a guy can do it. (smile)

Incredibly simple! You just pop the other plastic catch out with a butter knife and pop the other on in. This is the second time I have done this over the last 4 years or so.

I followed your short video and found it very easy to do

Took 3 screws out used the putty knife to pry the door a part then used the pliers to remove the old door catch and then sapped the new one and put the door back together and I was was done in less than 10 min.

took the cstch reciever out, with my fingers, pushed the new one in, snap lock fit.......couldn't be better, like repairing a model T ford.......

the part fit perfectly, it just snaped right into place.

Pop out the old latch and replaced with a new one

just put the new part in the door---sooo easy! THANK YOU!

After removing front door panel (2 screws) I removed the old latch catch and replace with the new part. 4 minutes later, the door was back together, the dryer was running and the door was staying closed.

Got my parts very quickly.
Popped out the old door latch with a screw driver and pressed in the new one.
Very simple.
Thanks Parts Select.