KSSC48FMS00 KitchenAid Refrigerator - Parts

This water tubing clamp keeps the 3/16-inch diameter water tubing mounted to your refrigerator. Its purpose is to prevent shifting, kinking, or loosening of the tubing, ensuring a consistent water flow for the water dispenser and ice maker. It is typically located at the back of the cabinet near the inlet valve. If the clamp securing the ...Read moretubing in your refrigerator is not properly secured, it can result in leaks or complete detachment. This poses a risk of water damage to your fridge, flooring, and nearby structures if not addressed promptly. To replace the clamp, refer to your user guide for its location. Then, use a screwdriver to remove the securing screw. Please note that this clamp is sourced directly from the original equipment manufacturer and does not include any additional hardware.

This refrigerator water filter housing securely holds the filter and directs water to the dispenser and ice maker, helping maintain clean, fresh-tasting water while reducing impurities such as chlorine and sediment. It also helps prevent leaks and protects the system from blockages. This part is commonly replaced when there are leaks arou...Read morend the filter, low water flow, difficulty inserting or removing the filter, or an ice maker that isn’t filling. Installation usually takes only a few minutes and involves reconnecting the existing 1/4-inch and 5/16-inch water lines and securing the housing in place.

A zip tie, also known as a cable tie or a wire tie, is a fastening device that holds wires or tubing together. If a machine has wires or tubing that are easily shifted, you need to hold them tightly together using a zip tie. It is a flexible, plastic strip that has serrated teeth and a locking mechanism. If the zip tie is damaged, it shou...Read moreld be replaced. Freely moving wires may rub against surfaces, causing them to break over time. Zip ties are single-use and may not be reused after they are removed from a machine. To release the locking mechanism, you will need to insert a small flat tool into the head of the zip tie, between the tongue and the serration, and depress the bar. You can then pull the teeth out of the mechanism to loosen the cable tie. This part is produced by the original equipment manufacturer and is sold individually.

This part is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation to keep the cooling coils from frosting over.

Sold individually.

The evaporator is always located on the inside of the refrigerator, usually inside the freezer compartment. It also resembles a radiator.