KSSC3 KitchenAid Refrigerator - Parts

Also known as a shaft.

The thermistor changes resistance as it senses the refrigerator temperature and sends a corresponding voltage to the pc board.

The body of this evaporator fan motor has four wires extending from the body, blue, red, yellow and one white one. This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Sold individually.

This part attaches to the wall and supports the drawer as it slides in and out.

This thermostat opens at 50 degrees Farenheit and closes at 25 degrees Farenheit.

This part helps control the ice cube release for the cubed/crushed ice selection.

The compressor relay and overload kit is an assembly for your refrigerator. The function of the overload is to protect the compressor from overheating by being mounted to the side of the compressor. The purpose of the relay is to boost the compressor. This assembly comes with two smaller plastic pieces that are less than two inches by one...Read more inch. One is black and the other is white. The kit also comes with a red wire tubing. The most common reason for needing to replace the overload and relay is if your fridge is too warm or will not start.

This screw is sold individually.