KSM4 - Parts

This part is used with Kitchenaid Mixers.

The speed control lever on your stand mixer allows you to adjust the speed that the mixer is running at. The lever is approximately 3.5 inches long, with a black plastic handle at the top. The speed control lever connects to the interior of your stand mixer, so you will have to take it apart to access the bar that the lever is attached to...Read more. Once you’ve opened the mixer, you can unscrew the old lever, taking care not to misplace the screw or washer that holds it in place. Replace the old lever with the new one, and then put the mixer back together.

Used with stand mixers.

Used on stand mixers to help keep the bowl in place.

This white bowl arm lift is just under two inches long. It is used for some of Whirlpool's brands of mixers.

Use with stand mixers. Screws are not included. Cap only.

Use with stand mixers.

This is a powder coated dough hook used on stand mixers.

This clear pouring shield is eleven and a half inches long. Use it for your food processor.

This chrome-finished attachment hub cap is designed to cover the accessory port on compatible stand mixers, providing both protection and a polished appearance when attachments are not in use. Crafted from durable materials, it helps shield internal components from dust, debris, and moisture, preserving the mixer's performance and longevi...Read morety. The cap is secured in place using the mixer's attachment thumb screw and is compatible with select models from Whirlpool and KitchenAid. For proper fit, confirm compatibility with your mixer model before installation.

Used on Stand Mixers.

This speed governor, or clutch, can typically be found in your tilt-head or bowl-lift mixers beside the control plate. It is one of the three parts that work together to regulate and control the mixing speed. If you notice speed fluctuations or unresponsiveness to adjustments, the speed governor may be malfunctioning. To replace it, consu...Read morelt your user manual for instructions. Start by disconnecting the mixer from its power source and removing the beater and bowl. Take off the rear cover and unscrew the mounting screws from the trim to remove it. Disconnect the wires on the control plate and pry the end seal from the appliance. Remove the fasteners on the control plate to access the governor, which can be wiggled off the shaft using pliers. Please be aware that this OEM part is sold individually.