My Orders
- Home
- KSM3316XBM0
- Instructions
KSM3316XBM0 KitchenAid Mixer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
After sitting on my kitchen counter for nearly 42 years the rubber feet left foot prints.
14 of 16 people
found this instruction helpful.
-
Susan from Gig Harbour, WA
- Really Easy
- Less than 15 mins
We:
tipped the mixer over on its side
pulled the old feet off
put the new feet in place and pounded them w/our fists
set it back up on its new feet
smiled
tipped the mixer over on its side
pulled the old feet off
put the new feet in place and pounded them w/our fists
set it back up on its new feet
smiled
Was this helpful?
Thank you for voting!
The 5 feet on my Kitchen Aide, had worn out
8 of 9 people
found this instruction helpful.
-
Beverly from Post Falls, ID
- Easy
- Less than 15 mins
-
Screw drivers
Took the old feet (5) off and put new on the Kitchen Aide, looks great. Stands high and your assistance on the phone, was so appreciated.
Was this helpful?
Thank you for voting!
Missing pedestal foot
4 of 4 people
found this instruction helpful.
-
Michael from CARLISLE, PA
- Really Easy
- Less than 15 mins
Turned the mixer on its side and slid the part into the bottom of the base.
Was this helpful?
Thank you for voting!
Lost a rubber foot on my Kitchen Aid mixer. The remaining feet we're hard and mushroomed. I decided to replace all 5. That was the correct decision.
-
Dale from Manheim, PA
- Really Easy
- Less than 15 mins
-
Pliers
I griped each foot with a pliers and twisted it out of its setting. I then set a new foot in place and hammered it into place with a small hammer. The feet fit snugly and did not need to be glued. Job was easy and mixer sits like new. I was glad I spent the money to replace all of the feet at once.
Was this helpful?
Thank you for voting!
Base lost grip
-
Miya from Seattle, WA
- Really Easy
- Less than 15 mins
-
Screw drivers
Put on a new base plate using fresh screws, all ordered on Parts Select in under a minute. Now my grandmas old Kitchen Aid Stand-up mixer is as good as new! This was way easier than I thought it would be and really a great experience!
Was this helpful?
Thank you for voting!