My Orders
- Home
- KSGG700EBS6
- Instructions
KSGG700EBS6 KitchenAid Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Oven temperature was WAY off, sometimes 50 degrees.
12 of 16 people
found this instruction helpful.
-
Sarah from Raleigh, NC
- Really Easy
- 15 - 30 mins
-
Screw drivers
Turned the breaker off. Removed the racks, pulled the oven out and removed the back. Disconnected and unscrewed the old sensor from the back, connected and screwed in the new one. Returned the racks and slid the oven back in.
The only remotely challenging part was disconnecting the old sensor. I had to figure out where to pres ... Read more s with the flat screwdriver to get it to release.
I had found a good YouTube video and didn't use the app.
The only remotely challenging part was disconnecting the old sensor. I had to figure out where to pres ... Read more s with the flat screwdriver to get it to release.
I had found a good YouTube video and didn't use the app.
Read less
Was this helpful?
Thank you for voting!
burned the rubber feet off of the burner grates
5 of 7 people
found this instruction helpful.
-
Richard from MAGALIA, CA
- Very Easy
- Less than 15 mins
cleaned the hole and inserted glue, then the rubber feet.
Was this helpful?
Thank you for voting!
Faulty ignitor
4 of 5 people
found this instruction helpful.
-
Mark from HOLLAND, MI
- Very Easy
- 15 - 30 mins
-
Screw drivers, Socket set
Remove bottom plate take screws and hex head nuts remove wire unscrew ingnitor reverse process with new ignitor very easy
Was this helpful?
Thank you for voting!
Grate Feet fell off early
3 of 4 people
found this instruction helpful.
-
Richard from Highland Park, IL
- Really Easy
- Less than 15 mins
Used Silicone Rubber to "glue" them. It's heat resistant unlike super glue which is why 8 of them fell off. I only found 6 of them and had to order replacements.
Was this helpful?
Thank you for voting!
Ignoter gave out
2 of 3 people
found this instruction helpful.
-
Michael from CHICAGO, IL
- Really Easy
- 15 - 30 mins
-
Screw drivers
Opened oven... removed grates and bottom panel. Unbolted igniter has flange and end wire. Attached end wire to new igniter and reattached new igniter to gas flange. The rest in reverse and set oven and pressed start.
Was this helpful?
Thank you for voting!
door of oven came apart when plastic screw holders broke
1 of 2 people
found this instruction helpful.
-
patricia from chipely, FL
- Really Easy
- 15 - 30 mins
-
Screw drivers
put back together with parts ordered. Parts arrived in 2 days!!!! and saved my large dinner party the following day from being ruined. Thank you so much for your parts inventory and for Jenn Air supplying only the part needed and not the entire door. It was a life saver!
Was this helpful?
Thank you for voting!