KSB5SSMW4 KitchenAid Blender - Instructions

Intructions were simple. Pried off the old coupling with the screwdriver and applied presser to replace the new one on the spindle.

Comment: KitchenAid appliances are made to last unlike most other small kitchen appliances. They are made of strong materials and repairable where as other similar products get thrown out ... Read more when they break.

with a flat wrench grab the shaft and unscrew the coupling (note: left handed threads)... then install the replacement part.

Piece of cake. Part was expensive and shipping likewise. Very fast

I just followed the instructions to remove the old drive coupling and screwed in the new one.

easier than i anticipated. i thought i would have to tear the unit down to get this part installed, but the replacement came with (even an idiot can do it)instructions, and it took all of four minutes. Mike in Albemarle,NC..

Pretty muched followed the directions, but after reading all the reviews I knew what do to before the part arrived. Super easy. My blender had been out of commission for a while...now I'm back in business. Well worth the $14 (part and shipping).

Pry off the old, clean up drive threads, thread on the new one. easy as pie

Watched the video on the site on how to remove the old one and install the new one and it took me all of 5 minutes, at most. I almost threw it away. Super cheap repair. The product arrived in 2 days too. I am saving the site. They are great.

Thanks to everyone before me and their stories!
I felt confident enough to try repairing my blender myself ! ! !
I just placed a flat head screw driver under the coupler and pushed up on the screw driver, 3 or 4 more times around the coupler. It broke away and a metal disc was left, which I unscrewed and I just screwed the new ... Read more coupler on.
Thanks Again!

Followed the directions and used a screwdriver to pry off the old gear. Screwed the new one on - reverse thread. Easy as that.

used thin wire strippers to hold screw shat, than unscrewed one and screwed on the other. done

Popped off the old one and popped on the new one. It took no more then 30 seconds and the blender is like new again.

I unscrewed the old coupling and screwed on the new coupling from Partselect.
This was a personal repair job.
However, I am a local Handyman in Northern NJ that does a ton of minor repairs. For all of my appliance part needs I will buy from Partselect.com. They under promised and over delivered! Just incase you dont know what I ... Read more mean by that statement,,, I ordered the blender part, they told me I would have it in 6-10 days (which was acceptable to me) and I had it in two days... AWESOME job FOLKS!!!!!!!

Forget about the repair blogs. The coupling includes a repair instruction sheet. It actually took longer to read the sheet than it did to do the repair. Follow the repair sheet instructions. Very easy, however not intuitive.

After I discovered that it needed to be screwed on turning to the left it was simple.