KSB5- KitchenAid Blender - Instructions

Followed the directions and used a screwdriver to pry off the old gear. Screwed the new one on - reverse thread. Easy as that.

used thin wire strippers to hold screw shat, than unscrewed one and screwed on the other. done

Popped off the old one and popped on the new one. It took no more then 30 seconds and the blender is like new again.

I just followed the instructions to remove the old drive coupling and screwed in the new one.

Pry off the old, clean up drive threads, thread on the new one. easy as pie

easier than i anticipated. i thought i would have to tear the unit down to get this part installed, but the replacement came with (even an idiot can do it)instructions, and it took all of four minutes. Mike in Albemarle,NC..

Pretty muched followed the directions, but after reading all the reviews I knew what do to before the part arrived. Super easy. My blender had been out of commission for a while...now I'm back in business. Well worth the $14 (part and shipping).

Just like the directions said, I pryed up on the coupling at a few points around it's circumference and it became loose enough to unscrew. I didn't believe it was going to work at first but, amazingly, it did. All that was left to do was screw on the new part. No problem!

Used a wrench 19/64 flat

with a flat wrench grab the shaft and unscrew the coupling (note: left handed threads)... then install the replacement part.

Because the old coupling was so tightly screwed onto the shaft it was necessary to use very flat wire crimpers to slide between the old coupling and the blender housing to grip the shaft and immobilize it while pliers were used to grasp the old coupling and loosen it---rotate clockwise.

It was very easy to unscrew the coupler I used locktight to put on the new part. Thank you sending
the right part the first time
Albert

Released cup drive with screw driver and un-screwed, screwed on new driver.
That is all, works like a new blender.

it was too easy, i only used my hand to screw the coupling to the blender.

The coupling split apart on my Kitchenaid Blender. I ordered the coupling part and "Bingo", I was back in business. It took no time at all and one screwdriver. I saved penty of money by not having to buy a new appliance.