- Home
- KRFC704FSS02
- Instructions
KRFC704FSS02 Whirlpool Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Filterer
3 of 3 people
found this instruction helpful.
-
Olga from COLLEGE STA, TX
- Really Easy
- Less than 15 mins
Easy
Was this helpful?
Thank you for voting!
replaced water filter
3 of 3 people
found this instruction helpful.
-
Virginia from POLSON, MT
- Very Easy
- Less than 15 mins
Had a hard time getting the refridgerator part of the filter to LET GO. The grooves weren't lined up with the areas meant to pinch. A knife on each side got it to release.
Thanks.
Have a good one.
Thanks.
Have a good one.
Was this helpful?
Thank you for voting!
Ice make auger stopped working
3 of 4 people
found this instruction helpful.
-
John from WADING RIVER, NY
- Difficult
- 30 - 60 mins
I carefully matched the model number to replacement part cross-reference and ordered the Part.
You-tube instructions were accurate except for the plug wire that prevented removal of the auger motor. It took significant maneuvering to drop the old motor. The new motor fit in better but the male plug configuration did not match the f ... Read more emale plug from the refrigerator.
A lot of wasted effort and time as well as expense! What good is matching replacement parts when the replacement is not correct?
You-tube instructions were accurate except for the plug wire that prevented removal of the auger motor. It took significant maneuvering to drop the old motor. The new motor fit in better but the male plug configuration did not match the f ... Read more emale plug from the refrigerator.
A lot of wasted effort and time as well as expense! What good is matching replacement parts when the replacement is not correct?
Read less
Was this helpful?
Thank you for voting!
Changed water filter. Water came out slowly. took off filter and reinstalled water came out good stream. Ice maker is still not working.
3 of 5 people
found this instruction helpful.
-
Orville from Albuquerque, NM
- Difficult
- 30 - 60 mins
Just stood in front of the refrigerator and disconnected the water filter and replaced it with the new one I purchased from by hand
Was this helpful?
Thank you for voting!
No Problem This was a simple replacement of the water filter.
2 of 2 people
found this instruction helpful.
-
Charles L from ROSEVILLE, CA
- Really Easy
- Less than 15 mins
Lower the filter cover on the refrigerator, twist the old filter to remove it, install the new filter by pushing and twisting it, and close the filter door.
Using a pitcher, run water through the new filter until the excess carbon leavings are out then the water is clear and is drinkable
Using a pitcher, run water through the new filter until the excess carbon leavings are out then the water is clear and is drinkable
Was this helpful?
Thank you for voting!
Not making enough ice
2 of 2 people
found this instruction helpful.
-
Regina from CLINTON, AR
- Really Easy
- Less than 15 mins
Just open the filter and put it in the slot
Was this helpful?
Thank you for voting!
Agitator seized because of rust
2 of 3 people
found this instruction helpful.
-
Robert from FORT MYERS, FL
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Replaced motor
Was this helpful?
Thank you for voting!
Motor stopped working
2 of 3 people
found this instruction helpful.
-
Jason from Roanoke, VA
- Easy
- 15 - 30 mins
-
Socket set
I thought this was going to be much more difficult than it was. Take the bottom access door off (using a small socket - same size for all screws). Disconnect the plug to the motor. Unscrew the 4 screws holding the motor. Take the motor out. Unscrew the shaft screws on top (only 2) so you can manipulate it if need be up and down or sp
... Read more
in it. Insert new motor and make sure shaft is seated correctly into the motor head. Screw motor back in. Screw shaft back in. Plug up motor. Screw bottom door back on. You are done. EASY!! Took me about 10-15 minutes to do. Much easier than most things.
Read less
Was this helpful?
Thank you for voting!
Broken
1 person
found this instruction helpful.
-
Lee from TAYLOR, AZ
- Very Easy
- Less than 15 mins
Remove and replace
Was this helpful?
Thank you for voting!
Replace refrigerator water filter
2 of 4 people
found this instruction helpful.
-
Jim from BROADVIEW HTS, OH
- Really Easy
- Less than 15 mins
I followed the instructions in the appliance reference manual, and successfully replaced the water filter in 2 minutes, and reset the water quality indicator.
Was this helpful?
Thank you for voting!
Door alignment
2 of 4 people
found this instruction helpful.
-
Amy from INMAN, SC
- Really Easy
- 30 - 60 mins
I was sent the wrong part , when I questioned them said they did not have it so was directed to Whirlpool and they are making it and I might get it in May
Was this helpful?
Thank you for voting!
Both outside door handles turned very beige
23 of 76 people
found this instruction helpful.
-
Howard from Boynton Beach, FL
- Easy
- 30 - 60 mins
-
Nutdriver
Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discol
... Read more
oring refer handles. Thank you
Read less
Was this helpful?
Thank you for voting!