Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refrigerator came with can holder in door
15 of 18 peoplefound this instruction helpful.
Kathleen from Oxford, MS
Really Easy
Less than 15 mins
The can holder was worthless for our family. I lifted out the bin and replaced it with the new bin that can hold gallons of milk.
Was this helpful?
Thank you for voting!
new refrigirator / useless pop can dispenser
15 of 20 peoplefound this instruction helpful.
Louis from Taylor, MI
Really Easy
30 - 60 mins
I just had to exchange the bucket, right part the first time.
Was this helpful?
Thank you for voting!
Needed to replace gaskets in refrigerator door as they were cracking
12 of 12 peoplefound this instruction helpful.
John from LONG VALLEY, NJ
Very Easy
Less than 15 mins
Beware - the website does not indicate that doors are different sizes on this model refrigerator. Not paying attention I ordered 2 of the same size gasket which only fit the right side door - had to send one back and reorder left side from Whirpool directly.
The actual installation is very easy. It may take a day or so the g
... Read moreasket to feel like its actually making a good seal.
Read less
Was this helpful?
Thank you for voting!
small nub that holds pantry door had broken off
14 of 18 peoplefound this instruction helpful.
kAREN from CHEVY CHASE, MD
Easy
Less than 15 mins
Nutdriver, Screw drivers
For replacing end cap, LH pantry part: removed large pantry drawer removed two small upper pantry drawers removed glass panel and long braces---all these parts required no tools used 1/4" nut driver to remove 3 screws from broken end cap, LH pantry part and shook it to release it from the refrigerator used phillip
... Read mores head screw driver to remove drawer arms replaced metal drawer arms to new end cap, LH pantry part attached new end cap, LH panrty part to refigerator and finised by using nut driver on all 3 screws. then replaced other pantry dawers, glass shelf, and pantry cover. EASY!
Took a putty knife and Removed the old switch removed the spade terminals from the old switch and replaced them on the new switch and just pushed the new switch back in place
Was this helpful?
Thank you for voting!
Plastic slide on crisper drawer broke
12 of 14 peoplefound this instruction helpful.
James from Staten Island, NY
A Bit Difficult
30 - 60 mins
Ordered new drawer -- fast and easy to find the correct part on this site. I also felt that the price was very reasonable. Except for one thing, it would have been simple to slide the new drawer in. The original drawer has a white plastic "face" that is removable. "Removable" is a relative term. It took my wife and I over 2
... Read more0 mins to very carefully remove the face without breaking. One person could not do it --- you need to hold the drawer firmly while another pries the face off carefully. Once off, it was able to be pushed on to the new drawer -- be firm.
Read less
Was this helpful?
Thank you for voting!
Guide rail on the crisper drawer had snapped off.
12 of 15 peoplefound this instruction helpful.
Gerald from Campton, NH
Really Easy
Less than 15 mins
I ordered a new crisper drawer from PartSelect over the internet one morning at approximately 10:00am, and the product was delivered, non-express delivery, the next day at about 4:pm. The front coverplate of the old crisper came off easily, and snapped into place on the new drawer easily. The entire repair/replacement took less than 5 min
... Read moreutes. Service from PartSelect, from locating, to ordering, to rceiving the part could not have been simpler or more efficient. A 5 star experience.Thank you.
Read less
Was this helpful?
Thank you for voting!
Old gasket frayed & torn
10 of 10 peoplefound this instruction helpful.
Carl from HARPSWELL, ME
Really Easy
30 - 60 mins
Laid gasket in direct sunlight for an hour, heat made it very pliable. Removed existing gasket from door groove, which came out with little effort. Pressed new gasket in door groove with minimal effort as it was pliable from sunlight heat. Gasket seated correctly and resulted in tight seal.
Was this helpful?
Thank you for voting!
Remove the water filter to install the bypass cap
11 of 14 peoplefound this instruction helpful.
Phil from GREENFIELD, IN
Very Easy
Less than 15 mins
Pliers
Lower the filter bottom housing to gain access to the filter. Unscrew the filter and install the bypass cap. Secure the lower filter housing to the top assembly.
Was this helpful?
Thank you for voting!
Six months in use time to replace the filter
13 of 20 peoplefound this instruction helpful.
Michael from Long Valley, NJ
Easy
Less than 15 mins
It is simple, unscrew the old screw in the new one.
Was this helpful?
Thank you for voting!
Plastic peg hinging lid to drawer broke
9 of 9 peoplefound this instruction helpful.
Lee from North Potomac, MD
Really Easy
Less than 15 mins
Screw drivers
It actually took 1 day and 15 minutes to fix this problem.
I removed the drawers and shelves in the area around the pantry. I carefully took apart the sliders and plastic parts that comprise the endcap/temperature adjuster. Then I tried to replace the unbroken part into the assembly. At that point I realized that something
... Read more was wrong and I had ordered the wrong part. So I cleaned and put the broken part back in the refrigerator to wait for the replacement.
PartSelect customer service person was terrific and had the correct part on the way to my home immediately. I don't know how, but it arrived the NEXT day!
THEN, it took me 15 minutes to unscrew the sliders, endcap and replace both. Thank you PartSelect.
Read less
Was this helpful?
Thank you for voting!
Right side door gasket split open
9 of 9 peoplefound this instruction helpful.
Thomas from SPRINGFIELD, MO
Very Easy
Less than 15 mins
First, selecting the right part is more difficult than the repair. My Kenmore is an outdated model actually manufactured by Whirlpool.
Once I got the part I relaxed the gasket with a hair dryer - an important step suggested by PS. I then took old of the old gasket and removed it. The new one fits in the channel. Just press and
... Read moremake it is completely installed and flush.
Read less
Was this helpful?
Thank you for voting!
Cracked plastic on pantry drawer lid
10 of 12 peoplefound this instruction helpful.
Angela from Bay Village, OH
Really Easy
Less than 15 mins
Broken lid popped out, new lid popped in. No tools required. 30 seconds to replace. Great price, part shipped within an hour of placing my order and arrived the next day, although I only paid for standard shipping. Excellent service - will definitely order again if the opportunity arises!
Was this helpful?
Thank you for voting!
Leaking water tube connector/union
10 of 12 peoplefound this instruction helpful.
Roderick from NEWTOWN, PA
Easy
15 - 30 mins
Pliers, Screw drivers
Received the union I ordered, then discovered that the tubes were different sizes, so I had the wrong part. I had read elsewhere that it was necessary to trim the two ends of the tubes with a box cutter to stop the leaks - I did this, and the leaking stopped. I was then able to go to a local hardware store and get a 5/16 to 1/4 union and
... Read morereplace it. The leaking is stopped, and the water supply in the door is now working like new. No problem with partselect, but I did buy a caliper so that I can check tube diameters if I ever have a similar problem! This is a great site to find instructions - well worth the time to search!
Read less
Was this helpful?
Thank you for voting!
A friend dropped a jar of relish on the plastic window and cracked it.
9 of 10 peoplefound this instruction helpful.
Gene from Petaluma, CA
Really Easy
Less than 15 mins
Easy repair. Unwrapped the new cover; pulled the old one off by releasing tabs. Inserted new piece. Took less than 15 minutes. Looks like new. The replacement part arrived quickly from Part Select.
My Orders
