KP0 - Overview

This remote control is a device for adjusting your air conditioner settings. It requires two AAA batteries for operation. A malfunctioning remote control may have unresponsive buttons or signs of physical damage. You may also notice that your air conditioner does not consistently or promptly respond to commands from the remote control. Yo...Read moreu will then need to operate your unit manually, which can be inconvenient and limit access to certain features. Please note that this OEM replacement part is sold individually, and batteries are not included.

This spring clamp is designed for your room air conditioner. This clamp holds the fan blade on the motor shaft so it can rotate during operation. If your fan blade is wobbling on the motor shaft, you may need to replace it. The part is made of metal and is approximately 3/4-inch in diameter. This is an OEM part sourced directly from the m...Read moreanufacturer. This spring clamp is sold individually. Before you begin this repair, make sure your air conditioner is disconnected from the power source. To complete this repair, you will likely need to remove the air conditioning unit from the wall.

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This is a genuine OEM sourced replacement part designed for use with Makita planers. It helps to hold and secure the planer blade to the unit. It is made out of metal and it is sold individually. You would need a wrench to replace this item.

This tapping screw is an authentic hardware that is supplied by original tool manufacturer for use with a variety of Makita power tools. It has multiple uses depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this screw. Note this durable metal screw is sold individually.

This #191938-1 (CB-408) Makita carbon brush set contains two individual carbon brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. This brush set will fit the Makita tools listed at the bottom of the page. • Worn brushes are often the cause...Read more of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.