KMMF330PSS01 KitchenAid Microwave - Parts

This mounting plate is sourced directly from the original manufacturer for use with microwaves. It is a metal plate designed to support a microwave by attaching the microwave to the wall studs. If the mounting plate wears down or becomes damaged, it will cause the microwave to tilt and become unstable, potentially damaging the appliance a...Read morend the wall it is attached to. Therefore, it is important to replace the plate promptly. First disconnect the microwave from the power source and locate the fasteners that hold the mounting plate. Detach the old plate and align the new one with the existing mounting holes. Secure the plate and check that the microwave is stable and unmoving.

This diode, or high voltage diode, is used in microwaves. It is an electrical current control device that ensures power flows in one direction and not the other way. If your microwave produces no heat, heats inconsistently, or gets noisy, replacing this part can be the solution. The tools needed for this replacement are a nutdriver, plier...Read mores, and screwdrivers. First remove the microwave cover, then remove the old part by disconnecting the small thermostat. Replace with the new diode. Remember to use the diagram provided by the manufacturer for more instructions.

If your microwave is not turning on it could be due to your fuse needing to be replaced. This part protects the microwave by shutting it off if there is an electrical surge. This fuse is just over an inch long, is metallic on both ends and ceramic in the middle. Before beginning this repair, unplug the appliance and wait a few minutes bef...Read moreore starting. Remove the outer cabinet which is held in place with two screws. You will then locate the power cord which will lead you to the fuse holder. Determine if the fuse has blown. Using an ohmmeter, you should be able to figure out if it has blown. A proper reading is zero ohms, if it reads as anything else then your fuse has in fact blown. Simply snap the old fuse out of place and place the new one in.

This damper is an authentic OEM replacement assembly used in microwave/range hood combos. It includes the damper door and frame. It is designed to direct the flow of air through the vent duct, and the release of steam and heat from the appliance during cooking. Over time, the damper door and frame can wear down or become obstructed by foo...Read mored particles and debris. A faulty damper assembly will result in poor ventilation, uneven cooking, and excessive moisture buildup which can damage internal components in the appliance. Disconnect any wires or connectors attached to the faulty damper assembly and remove it from the appliance. Position the new damper assembly and reconnect the wires/connectors before securing it with the appropriate fasteners.

This authentic high-voltage capacitor stores and supplies electrical energy to the magnetron so that your microwave can heat up your food. It is a cylindrical component located inside the control area of the microwave. If the capacitor malfunctions, you may hear buzzing or humming noises, witness sparks or arcing inside the microwave, or ...Read moreexperience inconsistent or no heating of your food. As microwaves use high voltage, exercise extreme caution during the repair process to avoid injury. Even when unplugged, the capacitor retains a significant electrical charge. To replace it, start by unplugging the microwave and removing the glass turntable and support before proceeding. Refer to the user guide for instructions on accessing the capacitor within the cabinet. Discharge the capacitor by creating a short circuit between each terminal and between each terminal and the chassis. Do so by using a pair of insulated-handle needle-nose pliers to simultaneously touch both terminals. Alternatively, you can use a well-insulated screwdriver, touching one terminal and gently sliding it forward to the other terminal, holding it there for a few seconds. Avoid touching the metal part of the tool and be aware that this can result in a loud and startling popping sound. Once discharged, you can safely disconnect the wires and remove the mounting fasteners. Please note that this OEM replacement part is sold individually.