KHWS1 KitchenAid - Instructions

First let me say that I tried several places to get what I thought was a simple light bulb. This included several national hardware stores as well as a national electrical supply company. No luck. Went to the manual and PartSelect. Not only did you have it in stock, ship right away,at a reasonable price it arrived in a matter of days. One ... Read more would not normally think of receiving a "how to" video to change a light bulb but you did. That impressed me. Suffice to say the replacement went well and you can be certain the next time I need a part I will go to you first. I am also impressed with the organizations with which you are affiliated with. BBB, Norton, PayPal, money back guarantee etc. Thank You The entire process was made pleasant with your support.

Replaced light bulb.

removed grill cover, removed bulb plate, unscrew bulb, screw new bulb in socket,put bulb cover back on and screw grill cover back on. no issues whatsoever.

I took the four screws holding the bottom and top on out. Slid the inside out. Replaced the displacer by removing the old that was held by a clip to the tube. Slid the insides back into the jacket. Put the four screws back in and reinstalled the dispenser.

I turned off the water supply to the water heater.I unplugged the appliance. Disconnected the two water lines. The water heater was simply hanging on the wall, so it was easy to take it out from under the sink. I pulled the thermostat knob out. I opened the top cap and the front plate by removing the screws (4). I then removed the existi ... Read more ng thermal fuse and plugged the new one. I proceeded to close the water heater and installed it back using the same steps in reverse. It only took a few minutes for the water to get hot. Thank you to Instant Repairman for the right diagnosis.

Removed the top and side plates, pulled out the defective wire and installed the new one. Reassembled and reinstalled and it worked like new.

I didn't do the repair -- my husband did, said it was easy, had no problems what so ever! The new bulbs give a lot more light to the cooking area.

simply too the cover off the top vent area and removed the old one and replaced it with the new one

Removed the glass cover and replaced the bulb. Very simple.

The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.

Simply removed front of Microwave, removed the old charcoal filer and inserted the new one. On the grease filters, removed both of them from bottom of microwave and slid the new ones in place. That's all there was to it. No tools required.

You had alerted that it was imperative to unplug unit before starting to remove defective bulb. As described, there was silicon on bulb and socket and bulb broke upon my attempt to remove. Had to use needle nose pliers to get metal base of old bulb from socket, then all went well.

All the electrics worked on Amana microwave EXCEPT for the cooking function. Inspected the control board and found the upper switch on the door interlock was burnt. Installed new switch in minutes and everything now works fine. Unfortunately, had to purchase expensive two switch "kit" although only one switch was kaput. PartsSelect mai ... Read more ling was SUPER fast. Thanks for looking, Scott

Removed the tank & removed the oldThermostat, replaced with the new one.

remove 4 screws from top, front louvered panel snaps out. remove 1 screw from top of keypad, keypad pivot's forward and can be removed. There is a white mounting bracket inside left. Remove two screws, one top and one bottom, bracket lifts up and out. 3 sets wires are attached, mark them with masking tape, top, center, bottom and pull out ... Read more plugs. They can only attach one way. Using a very small screw tip, lift plastic latch from switch, it rotates out and is removed from the pivot pin. reassemble in reverse order after switches are replaced