KHWS0 KitchenAid Washer - Parts

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

This part continually measures the amount of water entering the tub. It will make adjustments if too much or too little water is present.

Used to help hold your bellow in place on your washer.

This is the replacement bellow clamp for your washer. It approximately 16 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place on the washer frame. The main reason you would want to replace the bellow clamp is if it is rusted or damaged, and it is not holding the bellow ...Read moreinto place. To remove the bellow clamp, simply use a screwdriver to pop the bellow clamp out of the groove it rests in. Place the new clamp back into the bellow groove until it snaps into place. This is an OEM part from the manufacturer.

This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear. NOTE: Per Manufacture, belt measures 48.22" long uninstalled and the belt will stretch To 51.53" when installed.

This set includes the 3 baffles ONLY.The screws are sold separately.

This hose attaches to water pump assembly. NOTE: As per the manufacture if the washer has an Eco Ball, it's no longer needed when the new hose is installed.

This part is the replacement detergent dispenser drawer for your washer. It is made of white plastic and is approximately 11 inches long, 6 inches wide, and 5 inches deep. The detergent dispenser is filled with detergent, which it dispenses during the wash cycle. If a lot of detergent remains in the dispenser after the wash cycle, your cl...Read moreothes aren’t getting clean, or you notice a crack or a break in the dispenser itself, it may need to be replaced. This is an OEM part sourced directly from the manufacturer, and is sold individually.

This hose goes from the drain pump to the back of the washer.

This hose can handle hot or cold water and is five feet long.

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.