KHMS18 KitchenAid Microwave - Instructions

Cleaned the interior of my microwave, cleaned the new plate and simply added to the turn area.

Replacement was easy as outlined in the microwave manual.

Unscrew lens and direct access to surface light cavity. Removed old light bulbs and replaced with new bulbs. Reassembled lens cover and turned lights on successfully. Took less than ten minutes.

Looked up the Whirlpool Co. and ordered the part. It was quite simple. Arrived in 2 days and I simply placed it in the microware. It was very very easy!

E. Robinson

This wasn't really a repair, just an replacement of the filters, which is a regular maintenance requirement.

Removed old screws and pieces of plastic. Replaced new grill vent with old screws. Could not have been any easier

All it took was 2 screws and it was done - could not have been simpler.

Remove two screws, remove grill/bracket, replace grill/bracket, replace two screws and your done. Recycle if You Can.

Replacement of new vent grille took less than 5 minutes. I just wished Kitchen Aid made a product that lasted longer than 3 years. My part arrived very quickly, less than a week. Service was great and so was your price. I had no problem locating a replacement part. Kitchen Aid would not give me the parts number so I did not know if I was ... Read more order the right part. But you photo really helped to narrow the correct part. Thanks

Set in place and installed 2 screws. Took less than 5 min.

It took me 15 minutes total - 5 minutes to clean the microwave, 1 minute to install three new parts, and 9 minutes to enjoy my celebratory glass of wine!

used screw driver to pry up old part. lifted right off. line up drive couple drive push on. repair took less than 1 minute to repair. works like new
Very Pleased with Parts Select replacement parts

Removed remaining plastic around 2 screws. I recommend a Magnetic Phillips Screwdriver, screw holes are a little Offset, and mount screws are small. I used Needle Nose Pliers to hold screw, to get it started. Really simple install.

Took out turntable and swapped out old one with a new bright and shiny
New one, ring that is. It was easy using the part from parts select
Thanks
Paul

Took this great-grandmother of 7 less than 3 minutes. Only needed a Phillips screwdriver. Easy as pie!