KHHS KitchenAid - Instructions

Having the correct model number helps:
Just place the parts in the microwave and it worked.

I was sent the wrong fuse by you. I had to procure a fuse in another manner. Very disappointing. The repair was simple. It just took longer because of the failure to send the correct fuse.

order new coupling and bought die, 10 X 28NF, rethreaded shaft and put cover and new coupling back on. Works fine. Thanks to Parts Select, I was able to rescue a $200.00 commercial blender for about $16.00, parts, and shipping.

took it to Buttermore appliance in Auburn Indiana and he changed the fan and added another fuse

Replace Magnetron and then I the inverter unit after I discovered the unit still did not heat properly. Inverter had capacitor that was cracked and I found a diode that was flashing over the printed circuit board.

Took the front off and behind a plate was the fuse, so I replaced it for what good that did!!!

The repair was easy, I just took off a few screws and found the broken latch spring. The real story is how easy it was to find the replacement spring from Partselect! I couldn't believe they had it, and even better yet, I ordered it one afternoon, and it came the next day with normal shipping! Unbelievable! Then I just popped it in and r ... Read more eplaced the covers I had removed and it was working again!

Took the the want burned out , and put the new ones.

Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.

Followed the instruction booklet that came with the microwave. Very easy.

I want to thank PartSelect for thier assistance with my grease and filters that were needed for our microwave. We just bought a home and although the appiances are still in good working condition and only 6 years old they have not been maintaned well at all. The filers needed replacing and our local chain of hardware stores do not carry ... Read more any of the sizes we needed. I went on line and found PartSelect.com and reviewed what they offered. I really could not find what I needed so I called customer service and the women on the other end of the phone went through in great detail as to the sizes and quantities I would need. I have since then received the filters and they were extremely easy to install and fit perfectly. Very helpful site. KDS

1. Unplug the power cord from the wall socket. 2. Remove the 10 screws holding the bottom cabinet cover in place. The bottom cabinet cover will swing down allowing acces to the inside ofe the microwave. 3. Remove the connector from the turntable motor. 4. Use a T15 Torx driver to remove the 2 Torx screws holding the motor in place. ... Read more 5. Remove the motor. 6. Reverse the process using the new motor.

took the light assembly off and replaced the bulb and put the assembly together and fitted back in the space and finished the assembly.

replaced burnt parts

The screws broke out of the handle. After replacing it with a new one I realized a cheep fix would have been to get longer screws because in the broken handle there was still plenty of thread left. I ordered a new one from Part Select and received it in four days. You first need to remove the black plastic choke around the inside of the d ... Read more oor, I used a small flathead screwdriver then remove the two screws on the side of the door. Then with a flathead screwdriver unclip the metal frame from the door skin. Be careful though because at this point the panel can fall out the back. Then move the foam insulation and loosen the screws. Screw in the new handle and the rest snaps right back into place. I would not recomend hiring someone to do this. Its a 15 minute doit yourself project.