KHHC2090SWH1 KitchenAid Microwave - Parts

The charcoal filter, used in microwaves, removes food odors from the air. If your filter is damaged or you notice strong odors coming from your microwave, it is best to replace it. This part is metallic and measures about 12 inches wide and 6 inches deep. The tool required for this repair is a Phillips screwdriver. First, remove screws at...Read more the top of microwave to access the filter. Next, remove the old filter and insert new filter by pushing it all the way back, so the edges connect to the two tabs. The front edge of the filter should rest at the bottom of the cavity. Do not forget to replace the grill after installing new filter. Remember to unplug your microwave from the power source before installation process.

This surface light bulb is used in ranges and microwaves. It has a high voltage of 12 and 10 watts. This bulb illuminates and directs light at the bottom of the microwave or the inside of it. It also illuminates the top and bottom of an oven. If your bulb breaks, or the light flicks on an off, replacing it will solve your issues. Pro tip:...Read more High voltage capacitors in ranges and microwaves can retain lethal electrical change even when unplugged, to ensure your safety a technician should install this part. Refer to the manual provided by the manufacturer for further instructions.

Sold individually.

This door interlock switch is a genuine replacement part designed for use in microwaves. It serves a critical safety function by preventing the microwave from operating when the door is open. Because proper operation of the microwave’s shielding and interlock system is essential for user safety, this part should be installed by a qualifie...Read mored service technician. After installation, the interlock switches and microwave shielding must be thoroughly tested to ensure the appliance meets safety standards.

This part is a replacement glass cooking tray for your microwave. The cooking tray rotates when the microwave is running, and helps your food cook evenly. As it is made of glass, these glass cooking trays will occasionally crack or break. If your cooking tray is broken it may not rotate, and you will need to replace it. This part is sold ...Read moreindividually, and is approximately 16 inches in diameter. This is an OEM part from the manufacturer.

If your microwave is not turning on it could be due to your fuse needing to be replaced. This part protects the microwave by shutting it off if there is an electrical surge. This fuse is just over an inch long, is metallic on both ends and ceramic in the middle. Before beginning this repair, unplug the appliance and wait a few minutes bef...Read moreore starting. Remove the outer cabinet which is held in place with two screws. You will then locate the power cord which will lead you to the fuse holder. Determine if the fuse has blown. Using an ohmmeter, you should be able to figure out if it has blown. A proper reading is zero ohms, if it reads as anything else then your fuse has in fact blown. Simply snap the old fuse out of place and place the new one in.

This damper is an authentic OEM replacement assembly used in microwave/range hood combos. It includes the damper door and frame. It is designed to direct the flow of air through the vent duct, and the release of steam and heat from the appliance during cooking. Over time, the damper door and frame can wear down or become obstructed by foo...Read mored particles and debris. A faulty damper assembly will result in poor ventilation, uneven cooking, and excessive moisture buildup which can damage internal components in the appliance. Disconnect any wires or connectors attached to the faulty damper assembly and remove it from the appliance. Position the new damper assembly and reconnect the wires/connectors before securing it with the appropriate fasteners.

Also known as the coupler. This driver is located directly under the glass turntable, and over the motor. This part helps the glass turntable to rotate.

This microwave door interlock switch is a critical safety component designed to prevent the appliance from operating when the door is open. It functions by detecting the door’s position—open or closed—and relaying this information to the microwave’s electronic control system. This ensures the unit only activates when the door is securely ...Read morelatched. Commonly used in microwave models experiencing issues such as failure to start or lack of heating, the switch plays a vital role in maintaining safe operation. Installation involves accessing the internal door latch mechanism and replacing the switch, which typically requires basic tools and careful handling to avoid damage to surrounding components. The switch is compact and designed to fit seamlessly within the microwave’s door assembly.

Sold individually. For white and almond models.

Waterproof seal.