KGCT0 KitchenAid - Instructions

I pulled the knobs off, lifted the broken skirts out and snapped the new ones in.

pull old knob off install new knob

TURN OFF THE GAS SUPPLY & POWER TO THE STOVE. Disconnect the gas line & power source to the stove. Remove the complete counter top stove and place it upside down on a flat surface to enable you to remove all the surrounding small screws with a nut driver, then separate the bottom from the top accessing the retaining ring holding the ceram ... Read more ic electronic Ignition in place, remove the electric wire from the the old igniter. The most difficult part of the job was removing the retaining ring and installing the new ring.Job successfully completed.

I took the melted knob off, located the part # went online and found this site. I immediately found the correct burner knob, ordered it, and it came very quickly to my home! I just popped it right on the cooktop, and it's as good as new.

the decorative backings on our stovetop knobs had become frayed, and I simply pried off the old ones,and installed the new ones. I have use Parts Select for years for various parts replacement, their service is quick and accurate. When I need a part, I always check here first.

Simiply pulled the old burner knob off and replaced them with the new knobs.

Easy as 1 2 3. Removed ruined knob and set new knob on post. That's it. Complete success!

The repain involved removeing two screws in each of the burners. Easy to fix. Looks like new now for a fraction of the cost of replacement.

Just replaced them.

removed old electric cooktop and install gas line and gas cooktop and change from natural gas to LP remove and replace orifice with new ones from kit, my cooktop called for 2 black orifices in the two small burners but did not come in the parts kit that I orded so I used 2 red orifices and it seems to work just fine.

just put them on and pressed down

Just replaced with the same color-almond

removed one screw lifted he brner took retainer off unpluged the igniter it had broken porcelen reversed the procedure everything worked fine

This was remove and replace of burner valve on a rangetop stove. Removed front pannel of stove. Removed lower panel support. Removed ignition/spark material/peice (slides right off). Unscrewed valve form underneath through access hole, and unscrewed gas connection on top. Removed and eplaced with new valve and reassembled everything in or ... Read more der. Fairly straight forward.