KFGD500EWH11 Whirlpool Range - Instructions

This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.

I didn't. Don't know how to get to light bulb to change it for this specific model

Pulled the old knob off, pushed the new one on.

cleaned the hole and inserted glue, then the rubber feet.

Took the old levelling leg out and screw the new one in.

Used needle nose pliers to remove flat spring steel piece which holds
knob onto spindle. Pushed replacement knob onto spindle - perfect fit.

Used Silicone Rubber to "glue" them. It's heat resistant unlike super glue which is why 8 of them fell off. I only found 6 of them and had to order replacements.

Removed the ice brucket,
Removed the light shield by releasing one screw using a nutdriver.
Replacing the bulb and reinstalled the light shield.

Your web site is one of the best and most helpfull service sites I ever used. Just wish that in the future you will ship parts overseas.

Simply remove two screws take old one off and line up and put new one on and replace the two screws. Couldn't have been easier.

Unplug range

Shut off gas supply

Remove rear panel screws and panel with nut driver

Disconnect power plug from broiler element igniter

Open upper oven door

Remove screw from the front of the gas burner.

Remove screw using nut driver from rear of gas burner

Remov ... Read more e gas burner from oven and pull cord through from rear panel

Using nut driver, remove igniter from mount on gas burner

Install new igniter on mount on gas burner using nut driver

Reinstall is reverse of disassembly

Connect power and turn gas back on. Test igniter by activating broil on upper oven

The Stove installation manual was accurate and complete. The valve kit was well marked for each part. It was easy to find the proper piece part in the kit. The machining and finish of the parts were top quality. The included instructions addressed clearly the protocol for returning items to the site.

Customer service perso ... Read more nnel were clear and helpful. Will do business with this site in the future.

Put the back of stove on blocks of wood to get high enough to screw the new leg in.

very expensive to buy the part but just tighten the screw intot eh predefined place.

Very easy. Take out the screws with the supplied wrenches and install new chrome. 5 minute job.

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new ligh ... Read more t bulb in was not the problem.