KDTM704ESS2 KitchenAid Dishwasher - Parts

This is a seal, but you may also know it as a door gasket and it is for your dishwasher. The seal forms a watertight barrier between the door and the dishwasher tub, deterring water from escaping during a wash cycle. If your dishwasher is leaking you will need to replace the seal, as it is likely damaged. The first step should be to check...Read more the seal for buildup of food particles near the sides and the bottom of your appliance.

This drain hose is 6 and 1/2 feet.

This is a door latch for various dishwashers. Door latches are designed to communicate with the control board of the dishwasher when the door is closed and latched shut. If your dishwasher is not latching shut properly, or if your dishwasher will not start when the door is shut, then this latch is likely broken or bad. To replace this doo...Read morer latch, you will need a screwdriver or drill, and a set of pliers. This latch is sold individually, and does not come with any securing screws or other parts.

This dishwasher detergent dispenser is a genuine OEM replacement part designed for select models from Whirlpool, KitchenAid, Maytag, Amana, and other affiliated brands. Mounted on the inner door panel, it features separate, covered compartments for detergent and rinse aid, ensuring precise release during the wash cycle. The spring-loaded ...Read moremechanism is engineered to dispense cleaning agents at optimal times, enhancing overall wash performance. Constructed from heat-resistant, high-grade materials, this dispenser offers long-term durability and reliability. It replaces older components such as W10620296 and W10620298. Compatibility should be verified using your dishwasher’s model number prior to installation.

Sold individually.

This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.

The adjuster cover goes on the outside of the adjuster housing. It is used to support the height adjuster and also protects the internal components of the adjuster housing.

Sold Individually.

Sold individually.

This silverware basket is a genuine OEM replacement designed to securely hold utensils during the dishwasher cycle, ensuring thorough cleaning and preventing damage or loss. Constructed from durable dark gray plastic, it features a partitioned interior for organized storage and a removable handle for easy transport. Compatible with select...Read more models from Whirlpool, KitchenAid, Maytag, and Jenn-Air, this basket helps streamline post-wash sorting and supports optimal water flow around cutlery. Always verify model compatibility before purchase to ensure proper fit and function.

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.