KCS5 Kawasaki - Parts

This is an authentic Kawasaki replacement part, sourced from the original manufacturer for use with outdoor power equipment. The special recoil starter cam is commonly used to engage the starting pulley when pull starting the motor. This special starter recoil cam is available as an individual replacement part, please see model diagram for associative parts.

An authentic OEM supplied replacement part that is specially produced for Kawasaki hedge trimmers and clippers. This is one of the nuts that is used to secure the plate and the cutters. Please note one durable metal nut is included per order.

This is an OEM part sourced directly from the manufacturer. The knob is commonly found in Kawasaki hedge clippers and hedge trimmers. This part is made of high-quality plastic with a metal central insert, and is used to adjust the gear case joint. You may require an Allen wrench or hex key when replacing this part. This item is sold individually.

This wire is made for various makes and models of small engine power equipment. This wire is used to carry an electric current from one part of the equipment to another and is typically involved with the ignition and switches within your equipment. Depending on your model, this wire-lead may be used in a different position, so make sure t...Read moreo check any user manuals or diagrams for exact placement. This wire is an OEM part, made of high-quality metal with an outside rubber insulation, measuring approximately 4-inches in length, and is sold individually.

The Ring-Snap is used to lock the piston pin in place. This part is rated "Diffuclt" to install so please ensure you have full working knowledge before attempting to install. Installation will require pliers, a socket set and wrench set. If broken, then the pin may become loose, causing internal damage. If this happens you will hear inter...Read morenal engine noises. This part attaches inside the piston on either side of the piston pin, and if broken it should be replaced.

This is an authentic Kawasaki replacement part that has been sourced from the original manufacturer to be used with hedge clippers. The steel cutter is one of two blades that connect to the plate to make up the cutting assembly. A screwdriver and hex wrench are needed to install this item. The cutter is sold as an individual replacement part.

This OEM spring is used to engage the starter recoil cam when pulling the pull cord. Installation is rated as "Easy" and requires a screwdriver. This spring is part of the recoil assembly. If broken you may have difficulty starting the engine, and may feel like it is not engaging at all. If broken, it should be replaced.