JVM250BLC01 General Electric Microwave - Parts

This light bulb is a 40 watt, 130-volt clear appliance light bulb that is manufactured to fit microwaves with small-base light bulb sockets. The light bulb illuminates the inside of the microwave while the microwave is running. You may need to replace this part if the existing one is burnt-out or broken. If the existing light bulb is brok...Read moreen, disconnect power to the microwave and remove the bulb base with a pair of needle nose pliers. This is a common wear item, so it is recommended to order a spare. These light bulbs are sold individually.

This light bulb socket that is used in microwaves. The socket is meant to fit small-base light bulbs. * Please note: The light bulb is not included with this part and is sold separately. If the following symptoms occur, you may need to replace this part: existing socket is broken or cracked, light bulb is not turning on, or new light bulb...Read more does not work. Remember to unplug microwave before installing this part and refer to the manual provided by the manufacturer for installation instructions and a detailed diagram.

The secondary door switch is a simple on/off mechanism that stops the microwave from operating when the door is open (normally opened). The switch monitors the door latch position, and communicates whether the door is open or closed to the electrical control board. This door switch is approximately 1 inch long, and has 2 metal prongs cal...Read moreled terminals that extend out of its body. Common symptoms related to a faulty secondary door switch include: microwave will not turn/shut off, or the microwave will not heat properly. NOTE: Before you begin this repair, first make sure your microwave is unplugged, and that your capacitor is discharged. A capacitor stores large amounts of electricity even when your microwave is unplugged.

The screws are sold separately.

Unplug your microwave before attempting this repair. You will need to remove the grill, which is held into place by two screws at the top of the grill (open your microwave door before doing this). Remove the grill. Remove the screw on the left holding the control panel in place. Loosen the screw behind the panel. You should now be able to...Read more lift the panel up and pull forward to detach. You will find the door switch by removing the screws to detach the switch assembly. Press on the release tab to remove the middle switch. Disconnect the wire connector to release the old switch. The door switch is normally closed.

Introducing the Genuine OEM GE Appliances Vent Damper - a high-quality part specially designed for optimal performance. Crafted with precision, this notable accessory is vital in controlling and directing airflow through the vent duct. It's meticulously attached to the outer cabinet, forming a solid connection, ensuring a seamless operati...Read moreon of your appliance. This key part is commonly known as the Hood Damper Assembly, a significant component of your microwave. Before proceeding with the installation, ensure that the appliance is completely disconnected from all utilities to maintain safety. Trust in the quality and longevity that all GE products are known for.

Also known as Thermostat or Humidity Sensor for Fault Code.

This diode has a 1/4" female connection and an eyelet.

The thermostat opens and closes if it gets too hot to run the vent fan.