JTP28CFC General Electric Range - Instructions

First of all, the sensor had the proper ohm reading...at ambient temperatures. I suspected the sensor because it would jump in large degree increments over 200°F. From what I read online, the only other part that would cause this was a faulty circuit board. I opted to try the $20 part first vs. the $200 part. It worked. One screw on the b ... Read more ack top of the inside is all that holds the sensor in. Pull the wires out and you will find a quick-disconnect. New part had the same connector (thank you). Thread the wires back through the hole and replace the screw. Works like a champion (verified with an independent thermometer. That is all she wrote. I only wish I purchased two, since they don't last that long... 4 years...or so. I just bought the house built in 2007 and empty for a year... and it took 45 minutes to cook a pizza, and even then the bottom dough was light. A house without an oven is like a hot dog without mustard!

just slipped it in

Identified part with Part Select, placed order. Opened the power breaker for the oven. Removed oven door (slides off) to improve access, removed burnt element (2 screw and 2 electrical blade terminals). Installed the new element and tested. Reattached oven door.

I unplugged the defective plug and replaced it with the new one. Took 5 min total

I ordered the oven rack on a Tuesday and received it the very next day - was wowed at the service.

I opened oven and pushed oven rack inside.

pull out defective seal with pliers clean area and press new seal into place making sure the spring clips on seal are completely inserted into door slots push ends of seal into holes in bottom of door

nothing to it.

Remove 2 nuts attaching element to oven. Pull element out 1" to 2" exposing electrical leads. Pull leads off old element. Replace with new. Toughest part is seeing the elements in a dark oven. Have a light handy.

turned oven off, pulled oven out from wall, removed back of oven, unscrewed sensor from oven replaced with new sensor, put back on, turned power to oven on, tried oven at 425, my temp. gage and the oven temp matched. a very easy fix.

First and Foremost turned OFF Electric Breaker that feeds OVEN. You will know it's off when the digital lights go out. Remove the Perimeter screws holding the Oven in its cavity. Then remove the upper Control Panel, simple remove the 3 screws attaching it to the frame and lift up. You will find the Thermostat in question. I took several ... Read more digital photo's of the hookup for reference. Then carefully remove the front two (2) screws holding the thermostat to the front panel. using needle nose pliers pull off the spade terminals, then go to the back of the oven and remove the sheet metal cover that run down the center. (this will be to remove the ThermoCouple located inside the lower oven). Reinstall the new Thermostat starting with the Thermocouple and just let it hang outside until you connect the Thermostat Terminals. Once you have remounted the Thermostat and secured it, just route the Thermocouple to the lower Oven, Reinstall the sheet metal covers, the front control panel, movethe oven back into the cavity and secure it to the wall. Turn on the Breaker and you are Good to GO.