All Installation Instructions for General Electric Range JP76*02

Old large 8" stove burner had burnt out, needed replace

7 of 7 people found this instruction helpful.

Stephen from GOFFSTOWN, NH
Really Easy
Less than 15 mins
Nutdriver, Pliers, Screw drivers

Simply took the replacement part ( PS244040, GE WB30X341) and did the quick direct swap using all the new pieces in the burner kit. UNPLUG the stove. Undo the titl arm screw, remove the plastic wire isolation block (2 spring clips), unscrew the 3 wires to the elements, screw the 3 wires to the new element, put in new bakelite wire isolati ... Read more

Read less

Was this helpful?

heating element burned out.

Joseph from Bremond, TX
Really Easy
Less than 15 mins
Nutdriver, Pliers, Screw drivers

Replaced 30 year old stovetop cooking element with no problems. Stovetop works great now.

Was this helpful?

The instructions on striping the wires was slightly confusing.

Katherine from Berkeley, CA
A Bit Difficult
15 - 30 mins
Screw drivers, Wrench set

I stripped one wire on the first burner. Then I realized that the terminals were the ones that could be left. Finding a replacement terminal has proved to be difficult. Once I realized my mistake I could change the other three burners very easily.

Other Parts Used:

Tilt Lock Hinge Mounted Surface Burner Kit - 6"

Tilt Lock Hinge Mounted Surface Burner Kit - 8 Inch

Was this helpful?

only half of burner working

KENNEDY from OCEAN GROVE, NJ
A Bit Difficult
30 - 60 mins
Screw drivers, Socket set

Replaced the old with the new following directions (mostly).

Was this helpful?

Bad Burner

Grady` from Titus, AL
A Bit Difficult
1- 2 hours
Nutdriver, Screw drivers

There was no burner listed like 40 yr old burner that failed. Got one the same size and connections. Cut old burner out of the stainless steel ring and new burner fit right in. New burner works great

Was this helpful?

JP76*02 General Electric Range - Instructions