JCK5000SF4SS General Electric Range - Instructions

After opening the Oven door, I removed the glass cover to view and locate the bulb, at the inside, top front of the Oven. Removed the burnt out bulb by pulling it in a forward motion towards the front of the Oven, slid the new bulb into place and the Oven is again functional.

I used a Trox bit to remove one screw, replaced the oven sensor and reinstalled the screw. The whole project took less than 5 minutes.

Replaced upper cooling fan and board on double oven by removing covers on top and back.

I ordered the glass assembly which promptly arrived and I proceeded to unscrew the broken glass assembly and (by myself) removed it with ease. I then placed the new glass assembly and replaced the screws. It was really an easy job, I just retraced my steps from removing the broken assembly and replacing it with the new assembly. By th ... Read more e way, it was the first time I had done this.

there was one screw holding it on the back wall of the oven. It was easy enough that my daughter installed it with my guidance.

Watched a video on how to replace , had no problem remaking the repair, part was a perfect fit and had no hang up or issues

Removed screws from front of oven, placed a table under oven 2” below, places two rollers on table and pulled out the oven. Removed screws, replaced fan and reassembled. Move into place and secured front. Cleared faults and worked perfectly.

Changed the Temperature Sensor as you suggested, but the problem of 40 minutes to reach a temperature of 375 degrees F. remained the same.

Remove oven light lens cover, remove the bulb and replace it with a new one.