J79402 General Electric Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Element burned out and started to deform
0 of 3 people
found this instruction helpful.
-
Kurt from Cortez, CO
- Easy
- 15 - 30 mins
-
Socket set
disconnected power
remove oven racks and oven bake shields
removed two bolts from end bracket plate on element
carefully pull bake element partly out until the electrical wires are visible, remove two small screws, remember the side of element each wire
attaches, red is power black is ground.
, replaced new ... Read more element in reverse order, reattach wires to element and snug tighten , not over tighten. Element worked
like new.
remove oven racks and oven bake shields
removed two bolts from end bracket plate on element
carefully pull bake element partly out until the electrical wires are visible, remove two small screws, remember the side of element each wire
attaches, red is power black is ground.
, replaced new ... Read more element in reverse order, reattach wires to element and snug tighten , not over tighten. Element worked
like new.
Read less
Was this helpful?
Thank you for voting!
The bake element started to crack and open in several areas.It was just a matter of time before it would of broken in half.
0 of 3 people
found this instruction helpful.
-
Jon from Killeen, TX
- Really Easy
- Less than 15 mins
-
Socket set
Turn the power of to the stove used a 5/16 socked and unscrewed the element from the stove. Used the socket to remove the wires from the element. Installation was easy make sure you hold the end of the elements where the wires attach so they do not bend when tightening. Everything is working and back to normal. Make sure you use the model
... Read more
number to get the correct part needed.Part select was the best and delivery was with in 5 days.
Read less
Was this helpful?
Thank you for voting!
Condo Had Very Old Drop In. Threw Away Drip Pans And Rings
-
Valerie from Ogden, UT
- Really Easy
- Less than 15 mins
Placed new ones on range. Exactly what I would do to wash them.
Other Parts Used:
Was this helpful?
Thank you for voting!
Threw away old parts!
-
Valerie from Ogden, UT
- Really Easy
- Less than 15 mins
Put bowl in and then slid rings around. Just like cleaning procedure. Easy. Thanks for your service.
Other Parts Used:
Was this helpful?
Thank you for voting!
The burner only heated half of the coils
-
Patricia from Tamaqua, PA
- Easy
- Less than 15 mins
-
Pliers, Screw drivers, Wrench set
The repair went well and once again my stove that was installed back in 1968 is working perfectly. We will be buying another 6" burner and 2-8" so we have them when they begin to burn out. We looked everywhere for a replacement and was told they do not make them anymore, but we found it here. Thank you!
Was this helpful?
Thank you for voting!
dirty drip pans and rim trims
-
Anna from Las Vegas, NV
- Really Easy
- Less than 15 mins
Threw away the old ones after lifting burner rings. Put new parts in place.
Other Parts Used:
Was this helpful?
Thank you for voting!
The Upper oven the lower element went out.
-
Norma from SAN JOSE, CA
- Really Easy
- Less than 15 mins
-
Nutdriver
Unscrewed the prongs to the old element. When the new element showed up I put the new element back in again. Had no problem with the replacement and my oven works great.
Was this helpful?
Thank you for voting!
Upper Oven Lower Element Burned Out
-
ROBERT from SEATTLE, WA
- Really Easy
- Less than 15 mins
-
Nutdriver
Took off the oven liners, took out 2 retaining screws, pulled out element, removed wires, reversed procedure, easy
Was this helpful?
Thank you for voting!
The oven coil burnt out visibly sparking at the failure point on the coil
-
Mark from Fort Wayne, IN
- Really Easy
- Less than 15 mins
-
Pliers
This model has a top oven and a bottom. The repair was to the top oven. I shut off the electricity to the oven at the circuit breaker box.I removed the grates and unscrewed the two screws holding the burner in place. I gently pulled the burner free along with its two attached wires. I removed the two screws that retained the connections
... Read more
to the burner. I installed the new burner in the reverse order. Turn on the circuit. Good to go.
Read less
Was this helpful?
Thank you for voting!
dirty drip pans
-
ELAINE from MURFREESBORO, TN
- Really Easy
- Less than 15 mins
My stove top is 35 yr old. & Lowes did not have drip pans that fit. these worked great & easier than cleaning the old ones. They just popped right in.
Other Parts Used:
Was this helpful?
Thank you for voting!
Old drip pans rusted out.
-
Joseph from San Antonio, TX
- A Bit Difficult
- Less than 15 mins
Range is 45 yrs old. New drip pans are different shape. This is only place which had them and VERY GOOD price. Delivery was quick, too!
Other Parts Used:
Was this helpful?
Thank you for voting!
element was not heating
-
JOHN from STREATOR, IL
- Really Easy
- Less than 15 mins
-
Pliers, Screw drivers
I unscrewed the screw that held the element in place and then took the hex head nuts holding the 3 wires off the old element. When taking the wires off, I had the new element next the old and put each on the same connection one at a time to make sure I replaced the wires in the same location they were on the old element. After connectin
... Read more
g the 3 wires, I reattached the element to the range.
Read less
Was this helpful?
Thank you for voting!
Needed to replace drip bowls & trim rings for hard to find older range top....
-
Viola from Sacramento, CA
- Really Easy
- Less than 15 mins
As easy as 1-2-3 !!! :) Lift up burners, place drip bowls down then trim rings, put burners down! Could not be faster or easier! :) I Could NOT find these parts ANYWHERE !!! :) After much aggravation, I was EXTREMELY happy to come across these parts at PartSelect, online! :) Thanks so much for the diagram, you made is sooooooo EASY to fi
... Read more
nd the precise parts that I needed, now I can cook !!! :)
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Drip pan replacement
-
Dave from West Hartford, CT
- Really Easy
- Less than 15 mins
Couldn't find drip pans locally that fit my stove. I came here by chance searching the internet and found the parts I needed and had them in my hands within a day or two!! Not a big parts repair story but excellent servic
... Read more
e and shipping!! Will buy from again when needed!
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Drip pans were disgusting.
-
Gerri from nashville, TN
- Really Easy
- Less than 15 mins
Just an easy replacement. Problem was, I couldn't find the parts. The service and turn-around was fabulous!
Other Parts Used:
Was this helpful?
Thank you for voting!