J486A3 General Electric Range - Parts

This 6 inch high rise burner trim ring is intended for use with detached style low rise tilt lock surface mount burners on ranges.

This 8 inch high rise burner trim ring is intended for use with detached style low rise tilt lock surface mount burners on ranges.

The broil element is located at the top of the oven and gives off heat in order to bake evenly. If you notice that the element is not heating up or is not cooking evenly it could be because it is broken or burnt out. The depth of the screw-on terminals is 2-3/4 inches and they are 1-1/4 inches apart. Does not include mounting bracket. All...Read more you need for this simple repair is small screwdriver. To complete this repair, you will need to first turn the oven off (or shut off the house circuit breaker), remove the two screws that are holding the old element in place, remove the two wires from the old part, and then connect them to the new part and screw back into place.

This 6-inch surface element provides heat for boiling, frying, and simmering on an electric range. Its 3-wire, tilt-lock design runs on 240 volts and produces about 1,325 watts. Replace it if it does not heat, heats unevenly, or has burned or broken areas. Before ordering, inspect the control switch, wire ends, and mounting parts. Confirm...Read more the size, voltage, wattage, and fit with the full appliance model. Turn off the correct breaker and verify that power is off before service. Let the element cool and secure each wire before testing.

This large broiler pan is found in the bottom of your oven and is used to catch drippings from broiling foods. This part includes the grate and bottom pan and is made of porcelain. The grate measures 15-1/2 inches wide by 13 inches deep and the pan is about 17 inches wide by 13 inches deep. No tools are required to replace this item, simp...Read morely pull out the lower drawer of your range, pull down the front of the drawer, slide the pan out and slide the new one into place. This is a genuine part sourced right from the manufacturer.

This tilt lock hinge mounted surface element kit includes an 8 inch element, three wire, 2450 watt surface element, and a terminal block with all three-wire units. These high rise elements do not come with an attached trim ring.

This bake element has screw-on terminals.

This sensor offers 16 ohms of resistance at room temperature, though the resistance increases as the temperature increases.

The length of this thermostat's capillary is 62 inches.

Hardware included.