IP45003 Inglis Washer - Parts

This screw is sold individually.

This spanner nut, also referred to as a lock nut, is a critical component that secures the inner tub to the drive block in large-capacity washers. Featuring a right-hand thread, it ensures the tub remains firmly in place during wash and spin cycles, preventing excessive noise, shaking, or vibration. A worn or damaged nut can lead to poor ...Read moreperformance and operational issues. Installation requires basic tools and disassembly; always disconnect power and water supply before beginning the repair.

This washer agitator base is a genuine OEM component designed to support the agitator’s movement during the wash cycle. Positioned beneath the auger, it creates the back-and-forth motion that moves clothes through water and detergent, helping to loosen dirt and improve cleaning performance. The base works in coordination with the washer’s...Read more motor to maintain consistent agitation. Common symptoms of a failing agitator base include the agitator not moving, poor cleaning results, excessive vibration, or unusual noises during operation. Replacement is recommended when the part is cracked, worn, or no longer functioning properly.

Sold individually.

CLIP-TOP&CAB-R PNL

This basket drive assembly is for washers. Basket drive assembly sits on top of the transmission shaft and houses the spin basket brake mechanism. The basket drive spins to rotate the basket during the spin cycle.

This part prevents the agitator shaft from leaking oil onto the transmission.

If your clothes washer is leaking, it is likely that there could be an issue with one of the hoses. If the hoses are in working order, you should check the washers connecting the hose to your unit. Rubber washers are tasked with enhancing the seal between the hose and washer. A faulty or damaged washer will not be able to perform this pro...Read moreperly, and water will be able to leak from the poor connection. This OEM part is sold individually, so make sure you order the quantity that is needed. The washer measures 1 1/16 inches x 5/8 inches.

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Sold Individually.

This spin tube T-Bearing is an inch long. Sold individually.

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.