HTT15BBMBRWW Hotpoint Refrigerator - Instructions

I didn’t do the repair because I ordered two grommets. When they arrived, one of the packages was empty! Instead of just sending me another one, they refunded the part so I still need one. By the way, I was not refunded half the shipping either which was more than the part itself.

I have not yet done the repair. After watching this repair video two problems came to mind. First I only ordered one grommet not knowing that there were two (or more I don't yet know). The second problem is that this video must be for a fridge from like the 1940, but it looks NOTHING like mine from 2008. The manual shows a bazillion parts ... Read more and frankly I'm just a wee bit afraid to get started, and I am generally very handy, buuuttttttttt I don't know about this one

Easy

took old motor out put new motor in and fan blade all done

took a little more effort than the video show to remove old module and replace new. Works fine now.

After removing 2 screws from freezer air duct and 2 screws and 2 self tapping screws from back panel, I removed all these, as well as the foam duct connector. Checked and verified 120 volts at the motor connector, indicating that the motor was bad. Ordered the motor, and 22 hours later, it arrived. 15 minutes later,and 6 screws reinstalle ... Read more d, it was up and running.

First I had to order the part. The part arrived quickly, but without mounting hardware or instructions. It was easy enough to determine the placement of the shelf, but had to locate mounting screws from the hardware store, drill two holes, secure the shelf.

I pulled the shrouding off, unplugged the motor and replaced it. The hardest part is slipping the fan blade off the shaft without breaking it. Works perfectly now. Also, the shipping fed-ex, regular ground was only 3 days here to arizona. Would use anytime

It was way to ez to install only a couple of minutes that's it

Took out vegetable draws, removed old cover and put in new vegetable pan cover. Then put back drawers.

I lifted old one out and place new one in

Pulled the two wires out from the access hole in the lower part of the refrigerator. Put them in the spade connectors on the new switch, and pushed the switch into place.

I removed the old shelf and even though the new one had a slightly different texture, it fit perfectly and the two crisper drawers slid right in.

it was slowing cracking for a long time, and repairs with duct tape and crazy glue were a futile attempt to avoid the inevitable; a new part altogether! Well a few moments searching your site for the exact piece were all that was needed. With 48 hours of placing the order I had it in my apartment and just slipped it into place! it was a ... Read more piece of cake!Thank you so much!

All I had to do was remove what I had on the shelf, remove the bins, replace the shelf and slide the bins back in, replace what I had on the shelf and close the door. I am so happy now when I open the refrigerator door and the new (unbroken) shelf has replaced that old broken one.