HS522WA Honda Snow Blower - Parts

This is an authentic replacement part manufactured for use with Honda small engines. The float valve is used to allow fuel into the bowl chamber and to stop the fuel from entering the chamber when it is full. This valve set is sold as an individual replacement part, please see model diagram for associative parts.

This compression spring is sourced directly from the original equipment manufacturer for use with Honda engines commonly installed on a variety of lawn and garden equipment. It is an important component that allows the throttle to retract. Over time it may wear out and lose tension eventually requiring a replacement. To ensure the correct...Read more installation of this hardware, check the diagrams of your specific model. Keep in mind this high-quality spring is made of durable metal and is sold as an individual component. You may need a screwdriver and pliers to perform this repair.

This is an original Honda replacement part manufactured for use with small engines. This is the seal for the oil cap/gauge. This intended to be a replacement for a worn out seal and is sold individually, please note the cap is available separately.

This is an authentic manufacturer-sourced replacement part which is specially designed for use with Honda engines commonly installed on lawn and garden equipment. The purpose of a this component is to provide a tight seal between components, make sure to refer to the appropriate diagrams of your model for the correct location and applicat...Read moreion of this hardware. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

This stud bolt 6x109 is an individually sold part that is silver and made of metal. This specific bolt has the function of mounting the carburetor to the engine. If thise stud bolt becomes damaged, worn, or broken over time, the seal may become broken, causing the engine to run rough due to excess intake of air into the engine. This is...Read more an easy repair to make, it just requires a wrench. The stud bolt attaches to the side of the engine on the intake.

This flange bolt is a genuine OEM replacement part for use in lawn and outdoor equipment. It has a diameter of 6mm and a length of 12mm. The bolt has a wider circular area that protrudes out from the bolt head, known as a flange. The flange prevents the bolt from moving or loosening during use. Over time the bolt may corrode, crack, or it...Read mores threads may wear down. In this case the bolt will need to be replaced. Visually inspect the other bolts in your equipment to ensure your order the correct number, as each bolt is sold individually. Use a wrench to remove any faulty bolts and install the new bolts in place. Be careful not to overtighten your bolts as you may risk damaging the equipment and the bolt.

This is a genuine Honda replacement part that is intended to be used with small engines. The metal lock pin is used to secure a part assembly like a ball bearing to a shaft like the governor arm. The lock pin is sold as an individual replacement part.

This is an 8mm hex nut, which is a six-sided piece of hardware that connects two parts together in your lawn equipment by keeping screws, bolts, or studs in place. Hex nuts are commonly used in areas of your machine that undergo high stress like in the blade assembly, engine or wheels. If a hex nut is broken, it may be cracked or corroded...Read more, and you may find that you cannot tighten it enough to hold parts in your machine together. If it is not replaced, the parts of your machine may come apart. To remove a hex nut, use a wrench to turn it counterclockwise. Before purchasing this OEM replacement part, keep in mind that this part is sold individually and consult your instruction guide to find out how many nuts your machine needs and where they are located. It is best to replace all the hex nuts at once because they wear out at the same time.