My Orders
- Home
- HMV3021U-01
- Instructions
HMV3021U-01 Bosch Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Fuse Blows when door is opened
8 of 12 people
found this instruction helpful.
-
STEPHEN from SAN MATEO, CA
- A Bit Difficult
- 15 - 30 mins
-
Pliers, Screw drivers
Replaced fuse and switches.This is an undercabinet microwave.
The fuse is located in top right but there is no access from the front of the microwave necessitating complete removal of the microwave from the cabinets and then taking the microwave cover off.
This is a terrible design,
Instead, I cut the vent grate on the top ... Read more right front of the microwave to access the fuse.
replaced the fuse.
Switches were relatively easy to replace...being careful to not pull wires out of connectors or breaking small plastic tongs and clips.
Microwave is still blowing fuses though. door alignment may be off.
Again, terrible design and lousy product quality.
The fuse is located in top right but there is no access from the front of the microwave necessitating complete removal of the microwave from the cabinets and then taking the microwave cover off.
This is a terrible design,
Instead, I cut the vent grate on the top ... Read more right front of the microwave to access the fuse.
replaced the fuse.
Switches were relatively easy to replace...being careful to not pull wires out of connectors or breaking small plastic tongs and clips.
Microwave is still blowing fuses though. door alignment may be off.
Again, terrible design and lousy product quality.
Read less
Was this helpful?
Thank you for voting!
Cracked front door panel
1 person
found this instruction helpful.
-
ALAN from RYE, NH
- Difficult
- 1- 2 hours
-
Screw drivers
Taking the door apart is fairly easy. However, transferring the glass panel to the new door is complicated. I took an hour to figure out that the new plastic door panel must be curled and spread apart in order to get the glass in the plastic tabs that secure it.
Was this helpful?
Thank you for voting!