My Orders
HMA301-53 Hotpoint Food Waste Disposer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Splash guard worn out
5 of 6 people
found this instruction helpful.
-
Aubrey from Hugo, OK
- Really Easy
- Less than 15 mins
pulled out the old and stuck in the new--so easy a caveman could do it.
Was this helpful?
Thank you for voting!
old one wore out and had shrunk and coming loose.
1 person
found this instruction helpful.
-
Tom from ORLANDO, FL
- Very Easy
- Less than 15 mins
Turn off power to unit (switch off) Put rubber gloves on and pulled out old guard. Then cleaned the area on the sides and the under the lip with wet paper towels. Crud had built up. Once clean push the new guard in. Since it was new it was tight .push down moving finger pressure around until it seated. Works fine.
Was this helpful?
Thank you for voting!
old splash gard became loose, felt always into grinder
-
robert from coral gables, FL
- Really Easy
- Less than 15 mins
just wet the surface of the new part and pushed it with some force into its place. It was real easy
Was this helpful?
Thank you for voting!