HL550200 Campbell Hausfeld Compressor - Parts

The purpose of a gauge is to register the pressure readings inside the tank. This replacement gauge is sourced directly from original equipment manufacturer for use with Campbell Hausfeld air compressors. The dial reads 0-250 PSI. Please note this gauge has a durable metal body and it is sold individually. You should only need a wrench and a thread-sealing tape to complete this repair.

This ASME safety valve is constructed of high-qualty metal, and is made for use with many air compressor models. Fastened to the manifold, the safety valve diminishes air pressure when the pump is not shut off at the proper setting. This important component is sold individually. A screwdriver, adjustable wrench and a pair of pliers are of...Read moreten necessary for the removal and replacement. Please refer to the specific manual for additional repair information.

This item is an original part from Campbell Hausfeld for use in compressors. The pressure switch unloader valve connects to the pressure switch. A wrench set and a screwdriver may be necessary during the installation of this part. The valve is made out of metal and will need to be replaced if it breaks since it can cause air leaks. This item is priced individually but also includes three nuts.

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to d...Read morerain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

This is a genuine part that is supplied by the original manufacturer for use with Campbell Hausfeld compressors. When plugged in, the power cord transfers power to the unit. This part is made of flexible plastic and metal, it is also sold individually. For installation, you will need a screwdriver to remove any covers or shrouds, and a pair of needle nose pliers to aid you.

This genuine OEM sourced replacement pressure switch is specially designed for Campbell Hausfeld air compressors. The purpose of this component is to control when the compressor should start and stop building up pressure. If it is leaking air the pressure switch should be replaced for a compressor to operate as intended. The default setti...Read moreng of this pressure switch are 105psi on and 140psi off. Keep in mind this high-quality item is sold individually.