HGD140 Waring Blender - Parts

This is a genuine replacement part sourced directly from the manufacturer. The crimp connector is commonly found in Waring juicers, blenders, and waffle makers. This part is made of high-quality plastic, with a metal crimping ring inside. It is used to join components in the electrical system of the machine. When replacing this item, ...Read moreyou may be able to remove the old part using pliers, or you may need to cut the wire as close as possible beneath the crimp. The new part can then be installed using a crimping tool. This item is sold individually.

This is a genuine Waring replacement part that is supplied by the original manufacturer for use with blenders. The switch is used to relay electricity from the power cord to the motor. This switch is a three position switch that includes a high, low, and off settings. The switch is available as an individual replacement part.

This is an authentic Waring replacement part manufactured for use with blenders. This lid is the outer ring used to seal the top of the blender jar. The outer lid is sold individually, please note the center lid is sold individually.

This is a genuine manufacturer-sourced part which is specially designed for Waring blenders. The coupling spins on the motor shaft to rotate the blades. This part is made of metal and is sold individually. To install you will need a wrench and screw driver. Just unscrew the drive coupling from the bottom of the blade assembly and screw the replacement on the same way.

This authentic item is supplied by the original equipment manufacturer for Waring blenders. The washer helps to provide a tight seal between connected components, unfortunately, over time it may wear out and begin to fail eventually requiring a replacement. It is an identical replacement for a missing or a faulty bushing that was installe...Read mored on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable material and is sold individually.

This part is available as an individual replacement. The jar is made out of plastic. When replacing this item no tools should be needed. It will need to be replaced if it becomes broken. This is an authentic Waring replacement part that is sourced from the original manufacturer for use with blenders.

This is a genuine Waring replacement part. The screw is commonly found in blenders and food processors. This part is made of metal, and comes with two lock washers already attached. It may be used in different locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to t...Read morehe parts diagram to be sure of ordering the correct part. You will require a screwdriver when replacing this part. This item is sold individually.

This is a genuine manufacturer sourced replacement part used on Waring blenders. The coupling is the part of a blender that transfers power from the blender's motor to the blade assembly. Over time, the teeth on blender coupling wear down until they no longer engage properly on the blade assembly. This coupling is made out of plastic and it is sold individually.

This is an authentic manufacturer-sourced replacement container which is specially designed for use with Waring blenders. The purpose of this container is to hold the ingredients that are being blended, please note the cover and the blade are both sold separately. It is a high-quality component which is made of durable plastic and is sold individually.

This is a genuine Waring replacement part that has been sourced from the original manufacturer to be used with blenders. The metal washer fits around the motor drive shaft under the coupler. This item is used to provide spacing between the motor and the coupler. This item is sold as an individual replacement part.

It is a genuine replacement part that is supplied directly from the original equipment manufacturer for use with Waring blenders. This is the special blade assembly which sits in the main container to chop the food. It is a high-quality component which is made of durable stainless steel and it is sold individually, please note the washers and other components are all sold separately.

This is a genuine item that is supplied directly from the original manufacturer for use with Waring blenders. It is an identical replacement for a damaged or missing blending blade assembly. This high-quality component is made of durable stainless steel and is sold individually, please note the seal is sold separately.