HG300100DI Campbell Hausfeld Compressor - Parts

This is an original Campbell Hausfeld replacement part manufactured for use with air compressors. The check valve is a one-way valve that allows air into the tank and prevents compressed air from bleeding out of the tank. A broken check valve will not allow the tank to stay at the set pressure, causing the motor to keep running which can burn out the motor. This check valve is sold individually.

Sourced directly from the manufacturer, this plug is an exact replacement part for a variety of air compressors. This part is sold individually, not as part of a kit or assembly. It is gold, made of metal, and will be found on the pressure switch. This part will leak when it has become defective and will need to be replaced if it is dam...Read moreaged or worn. When you install the part, apply Teflon tape to the threads before tightening it in place. You will need a wrench to complete this repair. Customers rate this repair as Easy.

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to d...Read morerain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

This is a genuine part that is supplied by the original manufacturer for use with Campbell Hausfeld compressors. When plugged in, the power cord transfers power to the unit. This part is made of flexible plastic and metal, it is also sold individually. For installation, you will need a screwdriver to remove any covers or shrouds, and a pair of needle nose pliers to aid you.

This is an authentic Campbell Hausfeld replacement part. The gauge is designed by the manufacturer for use in air compressors. This is a complete gauge assembly, used to monitor the pressure in the compressor tank. You may require a screwdriver when replacing this part. This item is sold individually.