HDA360-03 Hotpoint Dishwasher - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The dishwasher was missing the silvare basket
1 of 3 people
found this instruction helpful.
-
LuAnne from Fairview Heights, IL
- Really Easy
- Less than 15 mins
Just plopped it in, it fit perfectly! I love it! Very easy to order the part, and very fast shipping! I order it and it took a day to get to me!
Was this helpful?
Thank you for voting!
water valve was bad
2 of 6 people
found this instruction helpful.
-
keith from crescent, FL
- Really Easy
- 30 - 60 mins
-
Nutdriver, Pliers
very easy like you said
Was this helpful?
Thank you for voting!
Kenmore Dishwasher not cleaning good, have more pressure now, but still not cleaning as good.
2 of 6 people
found this instruction helpful.
-
lawrence from gonzales, LA
- A Bit Difficult
- 1- 2 hours
-
Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
Remove lower panels, turn off hot water supply, Turn off breaker to dishwasher. notice how power connector is orientated and how valve is mounted to chassis of dishwasher and remove Molex connector which supplies power to valve. The power to the valve is 120VAC when the timer gets to the appropiate cycle I measured the valve with no conne
... Read more
ctor attached with DVM set to Diode or ohms setting and got about .825. I measured the NEW part and measure about the same. Have towel under valve hoses for small amount of water will come out. remove small diameter hose , inlet water supply, remove 2 screws holding part with nutdriver to remove valve which exposes the black hose attached to valve. Hose has a hose clamp, use pliers to remove. good time to check and clean hoses. I unwrapped a coat hanger to run through the hoses for debris. to INSTALL reverse the above. clean water away from floor with towel. Turn on hot water supply, check for leaks, I did not have any leaks. Turn on breaker. You can stick a stubby screwdriver into the door close switch of front door which enables you to turn on (swing arm) dishwasher with door open to check water pressure. I have a great deal more water pressure and water from jets spray much higher than before. Old valve was clearly bad, but solenoid of valve still worked, which sucks in the arm when energized. I used a DVM on the 2 wire connector on valve to check for 120vac when cycle turns it on-measured good. I still don't have quite the same cleaning as before. It is 80% better, but something is still not right. My wife put in one of those pot cleaners (red) mesh plastic thingy on top rack--and found pieces of red mesh plastic in debris area, cleaned it out as best I could removing the 2 covers, but not sure valve is opening there or debris is clogged in there which sends pieces of food, etc. through hose to garbage disposal. Hose wasn't clogged. Cleaning better but wife is still saying not as good. The Pump is running good, cleaned dust and dirt out of pump with vacuum. 10 years old, thinking of removing dishwasher from counter and checking the pump area or change it.
Read less
Was this helpful?
Thank you for voting!
My dishwasher would not stay running.
0 of 1 people
found this instruction helpful.
-
Edward from Franklin, TN
- Really Easy
- Less than 15 mins
-
Screw drivers
Had to pull off the front cover where my problem was. Discovered a burnt out switch of some sort, looked it up on your site and found the part. It seemed expensive so I searched a few more sites and discovered you had the cheapest price. I ordered the part on Monday morning and used the cheapest shipping. 5 to 7 days is what i was informe
... Read more
d of so i figured it was worth the wait. I got home from work Tuesday and the part was at my door (wow!) I still had my dishwasher torn apart so I put the new part in and about ten minutes later I was washing a load of dishes! I would refer partselect.com to anyone. Thank you! I hope I never need to use your site again but if I do I've got it saved in my computer! (-:
Read less
Was this helpful?
Thank you for voting!
no silverware basket
0 of 1 people
found this instruction helpful.
-
Ron from Aurora, CO
- Really Easy
- Less than 15 mins
No story just locate partselect.com on internet, select part and order. Part received in a timely manner in great condition. Thanks
Was this helpful?
Thank you for voting!
Dishwasher quit
2 of 12 people
found this instruction helpful.
-
Chuck from Seattle, WA
- Really Easy
- Less than 15 mins
After doing dishes by hand for four months, I decided to take a look at the dishwasher. It took about 40 minutes to identify the problem and order the part fom PartSelect. The part arrived in two days and took two minutes to install. It's best not to rush into these things.
Was this helpful?
Thank you for voting!
Lower rack had rusted through in several areas.
-
Bill from Fort Myers, FL
- Really Easy
- Less than 15 mins
Pulled out the old and rolled in the replacement. The easiest part of the repair was ordering from the PartSelect website and receiving it via FedEx Ground the next day. Thank you PartSelect. Even my husband could have been successful with this.
Was this helpful?
Thank you for voting!
missing silverware basket
-
Laura from New York, NY
- Really Easy
- Less than 15 mins
part came in the mail and fit the missing space perfectly. no complaints. easy fix.
Was this helpful?
Thank you for voting!
Bought a manufactured home
-
Patricia from Loganville, GA
- Really Easy
- Less than 15 mins
with a dishwasher. Someone had 'packed' the silverware basket and there wasn't one in my dishwasher! Ordered one from here, when it arrived, opened the box, opened the dishwasher and placed it in the correct place. Closed dishwasher - DONE!
Was this helpful?
Thank you for voting!
Old Basket Broke
-
FRANCIS from WINOOSKI, VT
- Really Easy
- Less than 15 mins
Ordered a new basket it was a little large as I ordered the wrong size. I just broke of the tabs that held it in and now its perfect and larger !!!! Simple and great service !!!
Was this helpful?
Thank you for voting!
replaced dishwasher rack
-
tway from columbia, MO
- Really Easy
- Less than 15 mins
nothing to it. slid old one out, slid new one in. however, replacement was not the same model as the original.
Was this helpful?
Thank you for voting!
I was very disappointed in the in-the-door silverware basket most dishwashers are equipped with today and longed for the ones that have been phased out.
-
Shirley from Stoughton, MA
- Really Easy
- Less than 15 mins
I went to PartSelect online and easily found an exact duplicate of my old basket at a reasonable price. I ordered it, expecting delivery in about 3 - 5 days. It was on my doorstep 2 days after the order was placed. I opened the dishwasher door, set it in the place of my choice, and what a timesaver! Try it! You'll like it!
Was this helpful?
Thank you for voting!
Old valve had hairline crack and leaking
-
lawrence from lexington, NC
- A Bit Difficult
- 30 - 60 mins
-
Nutdriver, Screw drivers, Wrench set
2 screws to remove valve, turn water off, detach water line, detach plastic water outlet line, and put the new one on, reattaching everything in reverse. Electrical hookup was just two wires to solenoid. Slipped them off and back on new valve solenoid. Some difficulty getting support screws back in.
Was this helpful?
Thank you for voting!
Broken vent on microwave
-
Tom from Romoland, CA
- Really Easy
- Less than 15 mins
-
Screw drivers
Ordered the part and installed...easy and great prices.
Was this helpful?
Thank you for voting!
multiple rust spots on the old rack
-
Clifford from Saint Louis,, MO
- Easy
- 15 - 30 mins
-
Pliers, Screw drivers
Original part no longer made. Substitute too small by a half an inch. Corrected the problem by removing the 4 corner wheels from the old rack and put them on the new one. Now, it fits and works perfectly.
Was this helpful?
Thank you for voting!